20 Most Recent Sony KP-61HS10 61" Rear Projection Television Questions & Answers

0helpful
1answer

SONY rear projection TV KP61HS10 picture blurry, hazy

Issue is with main tuner since you have two of them. At least the tv is ok but that tuner is fubar.
9/7/2017 8:47:22 PM • Sony KP-61HS10... • Answered on Sep 07, 2017
0helpful
1answer

My display is arched on the top and bottom of

Convergence output ICs in your tv got defective and causing arched on top/bottom of screen.
Convergence output ICs will be replaced to fix tv problem. There is Convergence Repair Kit available along with photo instructions to fix tv problem and you can attempt to repair tv if you have little experience for that to understand those instructions. Or local tv repair shop will help you to fix the tv problem.
2/5/2015 10:32:45 PM • Sony KP-61HS10... • Answered on Feb 05, 2015
0helpful
1answer

Tv Problem

Sony TVs generate an error code. The front panel LED (red) will flash anywhere from one to eight times which can isolate the problem circuit. It is not always accurate.

If you have a test meter which can read DC voltages and resistance in ohms, you can locate the problem area. If you lack the expertice to do so, contact a sony authorized servicer. If you have the ability, start by checking fuses on the "G" board ( power supply board) and the "D" board or deflection board.

A major problem area in this TV is the convergence circuit. There are six fuses around the convergence output ICs on the "D" board.

If any are open, replaces the output ICs.
2/3/2014 5:44:49 PM • Sony KP-61HS10... • Answered on Feb 03, 2014
0helpful
1answer

TV has sound but no picture

Bad bulb?
9/18/2013 2:31:24 AM • Sony KP-61HS10... • Answered on Sep 18, 2013
0answers
0helpful
1answer

KP61HS10 Screen Goes Black, Audio Fine, Status Light Flashes 5 Times

Replace your convergence ic's and bias resistors. Good to go!
8/6/2012 3:43:31 AM • Sony KP-61HS10... • Answered on Aug 06, 2012
0helpful
1answer

My tv has a loud hissing sound from the rear.Sounds like an air leak.The stand by light flashes 5 times and the picture is all messed up.What can I check?

A suggestion here: Carefully remove back cover and plug set back in and turn on---DO NOT STICK YOUR HANDS INSIDE!---Try to locate where the sound is coming from---the 5 blinks is an error code--If model is correct as listed here I or you can GOOGLE the model number with "5 blinks" to see what that code means--clearly related to the hiss you hear.My money would be a high voltage issue but correct model number needs to be confirmed.
4/2/2012 4:30:24 PM • Sony KP-61HS10... • Answered on Apr 02, 2012
0helpful
1answer

Tv Problem

How many times does the light blink in between pauses? Also is your model the KP-61HS10 ? Please respond to this same post and I should be able to help you.
3/29/2012 4:02:19 PM • Sony KP-61HS10... • Answered on Mar 29, 2012
0helpful
1answer

Sony kp-61hs10 tv, has sound but picture goes black after 3 min.

I just had the same problem. If your lucky it might be a free 5 minute fix. The five light flashes mean impropper current. I took the front grill off, then behind that is another black cover, I took that off and noticed the circuit boards COVERED in dust. I then took an air can duster and blew off all the dust... works like new. No more flashes and in an out picture. The collection of dust was interfereing with the electrical current.

Ben
1/8/2012 8:49:05 AM • Sony KP-61HS10... • Answered on Jan 08, 2012
0helpful
1answer

Sony KP-61HS10 Rear projection TV blurry /shadows at first start

Sounds like the convergence ic's need to be replaced or resoldered. Sometimes it can be a microfuse if you are lucky. But my question is if you hit the focus button up front does it make it thru the auto convergence? Let me know. Have a good one.
12/4/2011 10:26:42 PM • Sony KP-61HS10... • Answered on Dec 04, 2011
0helpful
1answer

KDF-E50A12U MY TV KEEPS TURNING ITS

Hi,
When did you replaced lamp last time in tv?
If lamp has not been replaced in last 2-3 years then it seems time to get it replaced to solve the tv problem OR let me know does red standby light blinks when tv shuts off?
Thanks.
6/28/2011 9:32:52 PM • Sony KP-61HS10... • Answered on Jun 28, 2011
0helpful
2answers

Light blinks, no sound or picture

The TV is on protect mode. The TV is forced to standby because a fault had been detected.

Try first leaving the TV power cord unplugged for some times, let say one hour or so.


Also ensure that the fault is not coming from a faulty receiver box sending bad signal, check if you get same problem with no receiver box or dvd connected.


If that does not work, and you keep having a flashing led on front of the TV, and tv turning off by itself after a while, that indicates a fault condition.

The flashing light indicates a diagnostic state called protection.
When the TV goes on protection there are only two possible reasons.


1The internal circuits are jammed because of electrostatic charges accumulating on capacitors, or because of a wrong voltage read by the main chip on your monitor controller board. this started the protection circuit.


2 The protection circuit detected a wrong voltage or abroken contact, identified an internal fault and kicked in , startingthe flashing light.



If you are in situation one, then theTV will reset just unplugging power cord for one or two hours,sometimes even minutes.


If you are in situation 2 , then there is an internal fault.


Common faults that can occur are a blown capacitor on power board, a convergence IC has blown, or a fault on Digital board.



If under warranty contact the manufacturer ringing the number on the user manual

If you want to repair at your own expenses, just locate any good qualified repairer.
6/4/2011 12:54:54 AM • Sony KP-61HS10... • Answered on Jun 04, 2011
0helpful
1answer

TRYING TO FIND REPLACEMENT CATHODE

www.tvrepairworld.com should have the CRTs available
5/10/2011 3:15:43 PM • Sony KP-61HS10... • Answered on May 10, 2011
0helpful
1answer

Is it safe to diy cleaning

Yes, just be sure to use canned air and a lint free cloth.
Hopefully this helps.
Thank you.
2/28/2011 11:58:56 PM • Sony KP-61HS10... • Answered on Feb 28, 2011
0helpful
1answer

Red light on TV is

That usually means poor emmision on one of the tubes or an EHT fault.

The AKB circuit (automatic kine bias), the timer/standby indicator blinks for about 30 seconds then goes to the self-diagnosis function. Something is wrong with the video. Check video out, Q705, 732, 761 and other components on the C board, also check Q218, 219, 220 on the A board. In addition, unit could be in IK blanking, try turning up screen slightly.

Hope that points you in the general direction.

2/20/2011 6:14:58 PM • Sony KP-61HS10... • Answered on Feb 20, 2011
Not finding what you are looking for?
Sony KP-61HS10 61" Rear Projection Television Logo

156 questions posted

Ask a Question

Usually answered in minutes!

Top Sony Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76849 Answers

Nasir Muhammad
Nasir Muhammad

Level 2 Expert

252 Answers

Cindy Wells

Level 3 Expert

6491 Answers

Are you a Sony Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Sony Televison & Video

  • Sony Televison & Video

Most Popular Question

tv sound but no picture

  • Televison & Video
Loading...