20 Most Recent
Fuji FinePix A360 Digital Camera - Page 9 Questions & Answers
4.1 a360 camera not working
Fuji Support site will quoter a repair price.
I suspect it will be well on the way to the cost of a new camera.
Fog in the viewer
When you say viewer to you mean the LCD screen or the optical finder[if it has one]?
In either case this is a fault that only Fuji can help with
Zoom error
No solution
repair probably as expensive a replacement
Contact Fuji the do a swap out at a discount service
FUJIFILM A360
Fuji Customer support will advise on this
Possibly a known fault.
Help
Time for a new camera.
Battery Problem
Hi,
thsi indicate the internal short in circuit which draining excess current and battery get discharged.
You nee dto chek internal circuit from technical expert. some component must be short .
let em knwo when it solved.
thanks
Sangita
LCD screen is white
It is not likely that the x-ray machine goofed up your camera's circuit.
It is more likely that the vibration on the plane loosened a flex connector, possibly a chip has failed.
A reputable repair shop is the answer for this.
Focus error finepix hs10
About the HS10 autofocus problem, I discovered the cause and solution. It is a problem of camera design, and is caused by three screws securing the CCD sensor. These screws are not properly secured and the vibration eventually dropping.
In two cameras with the same defect, the screws were loose. These screws adjust the sensor position relative to the lens and the sensor is loose when out of position not allowing proper focus.
The solution is to disassemble the camera and secure the screws.
These screws can not be too tight they need to be adjusted to position the CCD sensor correctly. The camera is difficult to dismantle because several wires are soldered.
Care must be taken to discharge the capacitor of the flash, this may cause an electric shock and burn the camera board.
Those who want to try the repair, follow the link to the service manual.
http://elektrotanya.com/fujifilm_finepix_hs10_hs11_sm.pdf/download.html
Milton Maenishi
I have a FinePix S1 and the display screen is not working. All other modes are working but no display
Many occasions LCD on camera display never fails but back light fails unless physical damage to LCD screen. Hold a torch to display when camera is on you will see faint(black and white) image means LCD is ok but back light is failed, it's replaceable but needs little skill to replace. Or replace full Screen with backlight. This is easy. Just remove back cover, remove display by loosening flex lock, put back new display carefully lock it holding flex with one finger. Please do not touch display flex contacts.
Not finding what you are looking for?