20 Most Recent Sanyo DS24424 24" TV - Page 4 Questions & Answers

Try unhooking the cable going to the selector buttons on the TV and see if it work ok with the remote, if it does the button cluster needs replacing, if it acts the same replace the main

Question makes no sense. If you have 'no tv' you can't program it. https://www.google.com/search?q=program+a+sanyo+vizon ..

Service manual in the link https://www.manualslib.com/manual/1898241/Sanyo-Dp19640.html https://www.google.com/search?q=Sanyo+model+DP19640+replace+fuse& ..

Thanks for the good article. I hope to see you with a better article than the one I am writing now. Thank you again :)

Read the Service Manual and see if it covers it. https://www.manualslib.com/manual/911464/Sanyo-Vizon-Dp37647.html Video help here https://www.google.com/search?q=sanyo+vizon+vertical+lines+on+tv ..

No, you buy a new facsimile remote or used one for that model. $30 for new, $7 for used. https://www.remotes.net/collections/sanyo-remotes?page=28 https://www.ebay.com/itm/174269913901 https://www.google.com/search?q=sanyo+dvd+player+dwm-270+replacement+remote ..

Try unplugging your TV for about 10 minutes and also hold the power button on the TV for about one minute and then plug your TV back in again and turn it on to see if the white screen is still showing up again. It could be the capacitors inside of the TV have gone bad or the powerboard is not working.Check the cables and the connections to your TV to make sure they are fully connected. Or the TV connections are bad and should be replaced.

Buy a new remote for it and stop using the buttons on the television! They are $20. https://www.google.com/search?q=sanyo+dp50842+remote+replacement .

Question edited for clarity, wrong type or 'which' / 'witch'. Videos in the link. https://www.google.com/search?q=Sanyo+television+which+has+a+white+screen But my advice https://www.fixya.com/support/r29790007-repairing_own_television ..

Hi, it's sounds like a group of the screens leds have overheated and/or burned out. If you just got the tv, this would be strange. However if you've owned it for years, then this might happen. Please attempt one power cycle and then flip through channels to see if the issue remains. If so, you might need to set a tv diagnostic-appointment with a company like geeksquad/ home depot after attempting a factory reset on the tv. Thank you.

Question edited for full 'make model (what it is)'. Question moved to Sanyo. Could be the power supply, it could be the main board. My advice regarding home television repair, unless our Television Expert Larry comes along. https://www.fixya.com/support/r29790007-repairing_own_television ..

If it is a Sanyo UNIVERSAL remote, here are the codes. It it came with a Sanyo television, it is single frequency and can't be changed.

CODE LIST - Magnavox

https://www.magnavox.com > controller=attachment PDF Brand of TV. (Device Selection Buttons: TV Button). Codes: Admiral. 0129,0130. Advent. 0036. Akai. 0102,0117,0034,0090. AOC. 0058,0063,0093,0096,0024.

go into picture settings and turn it off

Is it attached to the aerial/cable socket.? If it is, then the main control board has probably failed.? Changing it out is a fiddly but achievable job, but it's probably only worth it if you can pickup a used replacement part from eBay or similar.? Otherwise a brand new replacement board may be up to $150.?

What does the pop up say?

Hi, Please adjust your tv's contrast and brightness to try an overcome the issue. If there are accessories linked to your tv, please temporarily remove those accessories and restart your tv to see if the issue goes away. If all else fails, a factory reset would be the next option. Thank you.

Stop spamming. I have told you the answer three times.

Not available https://www.google.com/search?q=SANYO+ST-29KX3G+power+board+schematic ..

Hi " thanks for your question. please see this video

My Motorola cell phone is locked how to unlock