20 Most Recent Peavey PV6 Mixer - Page 9 Questions & Answers

Unfortunatly this could be any of a number of problems. i suggest taking it to the repair shop.

There is an external speaker jack on the back. Plug in a cab of your choice down to 2 ohm load. enjoy.

Contact Peavey customer service at this link- Peavey com

This is not user servicable. Here is a link to the service locator for peavey- Peavey com

look here, http://www.ko4bb.com/manuals/index.php?dir=06_Misc_Test_Equipment

Peavey com contact peavey directly and they'll send it to you.

Contact Peavey Customer Service. They can email you the schematic, and you can get the part directly from them.

You might try checking the capacitors and inductors wired inside. A blown cap is usually obvious, the inductor might be less so. But it shouldn't be too hard or costly to replace either. I don't have experience with this brand of speakers (or large high end speakers in general) but unless there is mechanical damage to some speaker component like the coil or cone, the electronics might be the next thing to check.

To get a replacement, Call Peavey and ask for the parts department. They normally sell things cheaper than you'd expect, and it will be the correct part.

yours is 1989 to 1991,sn 03557665 is 1988 sn 0368333 is 1990 Peavey Falcon User Manual Page 4 Peavey Falcon Made In Usa With Ohsc Peavey Guitar

RFeplace the fuse, then call Peavey Ciustomer Service.

Call Peavey directly. Peavey com

Contact Peavey directly. Peavey com

Contact Peavey directly for the correct info.

This will not be user serviceable. You will need to take it to the shop.

To adjust the intonation on a guitar you need the following. .. a electronic tuner and a small philip screwdriver when you tune a string say low E you play the note open and adjust tell it's in tune then to intonate play the low E at the 12th fret producing a Harmonic, view the tuner it will be sharp or flat, turn the small philip screw on the bridge adjustment it only takes a small turn one way or the other so go slow once the string is tuned at the harmonic note check to see if it's in tune played open, keep tuning and adjusting tell the strings are in tune open and at the 12th fret on all six strings once intonation is set properly the guitar will sound better really hope that helps?

YOur bet solution is to contact Peavey Customer Service. Here is their link- Peavey com

u just need to learn "google" https://www.google.com/search?q=Peavey+Multifex+Schematic&tbm=isch&tbo=u&source=univ&sa=X&ei=mO7-VPW-Nse-ggSr5oP4Dg&ved=0CDEQsAQ&biw=1498&bih=812

Could be a few things, most simple the Tubes, and or biasing, I have had a few amps that certain notes or chords would cause harmonic distortion within the tubes, and the tubes where good? Another possibility is the output transformer? Sometimes when they are failing the volume varies... hope this helps?

should say on the back of the pot