Top 20 RCA P52939 52" Rear Projection Television Questions & Answers

0helpful
1answer

Rca big screen model p52939

If you cannot get a good convergence then the convergence modules need replacing.
6/20/2017 2:30:03 AM • RCA P52939 52"... • 122 views • 0 helpful votes
0helpful
1answer

House power failure. Why doesn't TV restart?

Also, make sure its not on a gfci circuit. Even if a gfci is after the TV, like outside on a deck, a power surge may have damaged it. But that would most likely mean nothing in the circuit would work.
3/19/2016 10:26:19 PM • RCA P52939 52"... • 52 views • 1 helpful votes
0helpful
1answer

Power went out an when came back on tv wouldnt

Fault to the main power supply regulator section. Either it will be a separate board, or the part of main board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. http://electro-medical.blogspot.com/ It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and time. Even though you can make it right, it will cost around an amount equal to the cost of a new board; including the cost of (spare parts + service charge) More to say, most of the spare parts to it will be difficult to get from open electronic spare part market. This is true to most of the flat panel TV power supply boards; irrespective of its brand and screen size.
3/19/2016 10:35:55 PM • RCA P52939 52"... • 46 views • 0 helpful votes
0helpful
1answer

Is there a reset button on rca p52939

No there is no reset button . you would unplug the set for 5 min's and this will allow a reset . . with the symptoms you give id say you have a shut down issue . the set has detected a error and is putting it into a shut down sequence to protect it self from major damage .
10/15/2014 11:15:31 PM • RCA P52939 52"... • 129 views • 0 helpful votes
0helpful
1answer

Sound no picture

The Toyota Innova, 2010 vehicle...
10/25/2013 3:11:16 AM • RCA P52939 52"... • 39 views • 0 helpful votes
0helpful
1answer

How do you access the customer setup menu?

On this set with the remote or with the Menu button on the front of the set.
3/14/2012 4:59:52 PM • RCA P52939 52"... • 32 views • 0 helpful votes
0helpful
1answer

P60921 it's making beeping sounds

Thats almost always caused by the Flyback transformer and HOT transistor replaceing those should solve the issue. You can get the RCA repair kit with flyback and HOT for your model from www.tvrepairworld.com
8/4/2011 7:51:28 PM • RCA P52939 52"... • 97 views • 0 helpful votes
0helpful
1answer

3d like picture, from what

There is a small circuit board on the right hand side when you take the back off. This is the convergence power supply. If you know someone who can solder and desolder components they can change the chip and it should solve the problem. This is a STK ic chip mounted on a metal heatsink. If you have to call a repairman to do this a reasonable price would be 250 depending on the price of in-home visit. Fairly simple repair on this model. Good Luck, Russmann.
4/29/2011 12:28:38 AM • RCA P52939 52"... • 100 views • 0 helpful votes
0helpful
1answer

I have a model p52939 that when i turn it on

You can get the 239111 flyback with HOT transistor from www.tvrepairworld.com its listed under the RCA repair kits.
2/18/2011 12:20:42 AM • RCA P52939 52"... • 130 views • 0 helpful votes
0helpful
1answer

I can't get my tv

there should be an input button on the remote and tv that should fix this
12/19/2010 1:29:47 AM • RCA P52939 52"... • 45 views • 0 helpful votes
0helpful
1answer

My rca home theater system

Bad FBT flyback Transfomer and STK730-010
10/21/2010 6:06:29 AM • RCA P52939 52"... • 141 views • 1 helpful votes
0helpful
1answer

The picture appears like a

Projection TV sets are known to have two common problems. The first problem that is common to these sets is convergence failure. When this happens the TV will usually look 3D, Wavy/Distorted, etc. It may also shutdown and blink an error code.

The second common problem with Projection TV sets is dull video, halos around objects, white looking video, or red overpowers the screen. This is commonly caused by the fluid in the lens being clouded over.


You can find more details and solutions here on Fixya at the following link below. Or click HERE

3d884ac.pnghttp://www.fixya.com/support/r2861467-solution_video_looking_whiteish_dull
10/24/2010 5:08:55 PM • RCA P52939 52"... • 114 views • 0 helpful votes
0helpful
1answer

Blue, red and green are

Projection TV sets need to have all three colors - RED - BLUE - GREEN - lined up correctly on the screen in order for the video to look normal. When its out of alignment the video will look 3D, wavy, distorted, etc. Most of the time you just need to adjust your convergence in the TV menu. If you cannot adjust it in the menu - then your convergence is broken and needs to be repaired.
This is a very common failure on these projection sets and a fairly simple DIY fix. All projection sets including Samsung, RCA, Sony, Philip Magnavox, Panasonic, Pioneer, Akai, GE, JVC, Toshiba, and others at some point will have the same problem.
You can get a repair kit with parts and instructions from www.TvRepairKits.com
9/22/2010 4:17:01 AM • RCA P52939 52"... • 142 views • 0 helpful votes
0helpful
1answer

My rca home theater system

The image gets bowed when the S-correction circuit attached to the high tension module has failed.
If the entire tv has shut down then the high tension module (more precisely its power transistor) has also been damaged and will have to be replaced.
This is a very delicate fix that only a certified repairman can do. Unplug the tv from the wall to limit the damage and call one - it will cost you around $250 to fix it.
10/21/2010 6:05:09 AM • RCA P52939 52"... • 40 views • 0 helpful votes
0helpful
1answer

I unpluged the TV to

Sometimes the power cords come away from the back of the TV . Mack sure you snug it up or it could be that new out let. Have it tested with a hair dryer or something.
9/2/2010 10:50:03 PM • RCA P52939 52"... • 68 views • 0 helpful votes
0helpful
1answer

Tv keeps changing channels and wont stop

What you likely have is a bad (defective) button on the front keyboard of the set.

What I would do is unplug set, remove back cover and at the top of the three large black lens on a tiny circuit board locate the plug with wires that goes to the front of the set and its keyboard.

Unplug it so the keyboard up front is out of the loop. The set will still be able to be operated with the remote as the remote receiver is on that same tiny circuit board.

Let me know what you find, I am here to help


SD TECH
6/16/2010 12:40:34 AM • RCA P52939 52"... • 333 views • 1 helpful votes
0helpful
3answers

Cable works no channels found in channel search

Is your TV set up to "cable" rather than antenna in the settings before you do a channel search?

It sounds simple but It is something most people would overlook. Let me know and I will get back to you as soon as possible.
9/5/2010 12:12:56 AM • RCA P52939 52"... • 33 views • 0 helpful votes
0helpful
1answer

Screen is blurry and when

Clean and vaccuum inside the TV, make sure it runs cool. Then replace the screen from RCA service?
8/26/2010 5:53:11 PM • RCA P52939 52"... • 36 views • 0 helpful votes
0helpful
1answer

WE HAVE NO PICTURE OR SOUND AND YES IT IS PLUGGED

power supply board
5/20/2010 2:59:13 PM • RCA P52939 52"... • 121 views • 0 helpful votes
Not finding what you are looking for?
RCA P52939 52" Rear Projection Television Logo

Popular Tags

85 questions posted

Ask a Question

Usually answered in minutes!

Top RCA Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76851 Answers

Jaime Hernandez

Level 3 Expert

2351 Answers

Cindy Wells

Level 3 Expert

6556 Answers

Are you a RCA Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

RCA Televison & Video

  • RCA Televison & Video

Most Popular Question

rca home theater system

  • Televison & Video
Loading...