Top 20 Bush DVD142RC 14 in. TV/DVD Combo Questions & Answers

use a cleaning disc on thed dvd drive in the tv

Bush DVD142RC 14... • 76 views • 0 helpful votes

This may help if the tv as a 3.5 ear phone socket try your earphones & see if the sound works if it do's then its prob the switch in the ear phone socket that's @ fault and norm inserting & pulling out the ear phone plug a few times can clear it

Bush DVD142RC 14... • 205 views • 0 helpful votes

Most Big box stores have a DVD cleaner disk, located in the electronics section, which is fairly inexpensive. I would try that first.

Bush DVD142RC 14... • 378 views • 0 helpful votes

Contact Dealer.

Bush DVD142RC 14... • 84 views • 0 helpful votes

Laser pickup unit fault. It should be replaced. Contact any service technician. If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience.

Bush DVD142RC 14... • 1,366 views • 0 helpful votes

Most likely either a problem in the main power supply or the deflection circuit in the set---in plain words if the power supply is not for whatever reason coming on, the set will not come on.Also if a picture tube type set if the circuits downstream for the high voltage for brightness (which in most cases also provides voltage for sound) do not work set will not come on.About the only easy possible reason is a cracked solder connection somewhere or a part bad.Most of these small combo units are not made by the company whose name is on them and sadly are usually not repaired as considered by some a throwaway item.

Bush DVD142RC 14... • 159 views • 0 helpful votes

HelloThe power supply section of your TV should be troubleshooted. Open the set, and check the fuse. There is a protection fuse fitted on the power supply section, a glass cartridge type, which can be detached from its holder. Check it for damage. You can check it with the help of a multimeter. if found opend, never put an other fuse in place. Check for the reason for present fuse to blow up. There will be some reason, without any reason, a protection fuse won't blow up. If you replace the fuse with an other one, without detecting and rectifying the reason for the blow up of fuse, it may make things more worse than preset. Usually, power switching section will have the trouble. You must have sound knoledge in electronics to follow the work.If you have knowledge and all tools to repair, inform me by Fixya comment box. I'm ready to assist you to repair this set. OK.

Bush DVD142RC 14... • 124 views • 0 helpful votes

Please try using a univerrsal remote as the AV is switched only externally by this way. The other option is to short the AV switching transistor from the output of the processor but for this you must identify the pin and do it with care not to tamper the circuit.This can make the AV to be ON and so help you with the cam.

Bush DVD142RC 14... • 310 views • 0 helpful votes

  • When you get to the link click on "Click here to start download from MediaFire.." and the PDF will download onto your computer.

  • If you have any comments please feel free to leave them here.
  • Hope this helps and thank you for using FixYa.


Bush DVD142RC 14... • 262 views • 0 helpful votes

  • When you get to the link click on "Click here to start download from MediaFire.." and the PDF will download onto your computer.

  • If you have any comments please feel free to leave them here.
  • Hope this helps and thank you for using FixYa.

Regards, Tony

Bush DVD142RC 14... • 240 views • 0 helpful votes

You should have lost ALL of the channels. but for some reason in Va Beach, Hampton Roads,
there is 1 station. its a religous channel. That TV is obsolete now.


Bush DVD142RC 14... • 209 views • 0 helpful votes

Possible that the disc is warped and so is not loading, put in another disc and if there is a similar fault then the loading mechanism is also to be checked.

In most cases when the CD does not play it is possible that the optical head is a suspect. Sometimes it might pick up ordinary audio CD but will not play other formats. This indicates that the optical head is weak and so there is no detection or scanning of the CD . If the optical is working the tracks will be read immediately but with no scanning the laser head can be defective.
Sometimes certain cleaner disks will not be tracked to run for cleaning as it will not be read and so will reject. Hence it is ideal to manually clean the laser head eye using a cleaning swap /cotton bud with gentle pressure on the lens eye.
If there is no result then watch if the CD spins or tries to spin. If so the board seems to work unless a test is taken on the main board but the possibility of a defective optical head can be the suspected fault.
If any of the above seems otherwise we must recheck with possibilities of a malfunction of the main processor board

Bush DVD142RC 14... • 338 views • 1 helpful votes

There are two possibilities for this fault. The first one is the spinning problem of disc inside it. If loaded disc does not spins, the mechanism will eject it. The reason for this is damaged sled motor. Sled motor is one which spins the disc inside at high speed. It can be replaced. The second reason is of Laser Pickup Unit itsef. If it does not emit laser beam, the main system circuit will recogonise as there is no disc in the tray, and play function is energised, and will eject the tray out. Check for the first one. This is most comon fault with DVD players. OK.

Bush DVD142RC 14... • 601 views • 4 helpful votes

Its sounds to me like your laser in the DVD needs cleaning or the disk you are trying to play is damaged. First you should buy a lens cleaner for your DVD. They are quite cheap.! Then clean the DVD lens.
Try another Pre recorded DVD Film. If this does not work , then maybe your Laser lens is not working. This then is a job for a repair person.
Hope this helps.

Bush DVD142RC 14... • 404 views • 0 helpful votes


The answer is yes. The TV has all it takes to work with set top box. So it is definitely going to wok.....

Good luck.

Bush DVD142RC 14... • 127 views • 1 helpful votes

What kind of cable are you using to watch TV, component or coaxial? If you have the option to try either, see if you can try whichever one you haven't yet to see if the sound comes through on the TV portion. Doesn't hurt to try different cables.

Bush DVD142RC 14... • 133 views • 1 helpful votes

Very difficult to used tv without the original remote.Try website like to buy an original remote or very close to it.

Bush DVD142RC 14... • 781 views • 0 helpful votes

Try these codes available at:

If none of them work then sorry, you can't use it to view the disk.

Bush DVD142RC 14... • 125 views • 1 helpful votes

Not finding what you are looking for?
Bush DVD142RC 14 in. TV/DVD Combo Logo

140 questions posted

Ask a Question

Usually answered in minutes!

Top Bush Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76584 Answers

Raj Patel

Level 3 Expert

1042 Answers

Tom Chichester

Level 3 Expert

61759 Answers

Are you a Bush Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Bush Televison & Video

  • Bush Televison & Video

Most Popular Question

cannot retune tv bush tv dvd combo

  • Televison & Video