20 Most Recent Samsung PS42P2S 42 in. Plasma Television - Page 6 Questions & Answers

Pls report it to Samsung for remedy in warranty. Try to contact here.

Samsung PS42P2S... | Answered on Aug 25, 2008

2 Answers

Blue glow

Warranty comes from name brand on set contact them immediately.

Samsung PS42P2S... | Answered on Jul 19, 2008

2 Answers

Power swith ic went bang!

unfortunately these boards are now obsolete, it may have damaged the bridge rectifier

Samsung PS42P2S... | Answered on May 02, 2008

1 Answer

Flshing AMBER Light, will not power up

it sounds there is a fault in your board. You should contact tech-person for servicing your tv.......Just an idea... wait some other expert will describe better.

Thanks
Iqbal

Samsung PS42P2S... | Answered on Apr 24, 2008

1 Answer

Unless you haven't tried the suggested 000-??? for a Samsung tv then you're out of luck. Remote codes are supplied by the manufacture to go with units. If the codes they give don't work, then there are none.

Samsung PS42P2S... | Answered on Mar 08, 2008

4 Answers

No screen signal

You must start by checking the panel supply voltages, if you look on the panel inside the unit you should see a label with a lot of voltages on it, such as V-set, V-scan, Va, Ve, there are test points on the power supply board and DC _DC board, that has the test points and the small adjustors for those voltages, check and see if they are correct or not, then start unplugging the cables connected to the other boards and check all the voltages again, those supply boards have a latch on circuit that will cause it to shut down, if you have back lights though, it could be only a board swap, most of the time it's a logic board or main board or a Y-main board, but you poweer supply could still be defective, good luck

Samsung PS42P2S... | Answered on Feb 22, 2008

1 Answer

Two grey 3in lines at either side of screen

Yes take set to repair shop this is not a fix it yourself problem!

Samsung PS42P2S... | Answered on Feb 08, 2008

1 Answer

Plasma TV

Set needs to be taken in to repair shop this is not a fix it yourself problem.

Samsung PS42P2S... | Answered on Feb 08, 2008

1 Answer

Samsung 42 inch

Take to repair shop this is no easy fix it yourself problem!

Samsung PS42P2S... | Answered on Feb 08, 2008

1 Answer

Loss of picture

Take set to repair shop this is not a fix it at home problem!

Samsung PS42P2S... | Answered on Feb 08, 2008

1 Answer

Plasma TV problem - loss of brightness

Yes it can be repaired cost ???? Depends on you on how much your willing to spend on repair.Good Luck. ThankYou for using FixYa. Have a Nice Day.

Samsung PS42P2S... | Answered on Feb 08, 2008

1 Answer

Ps-42p2st samsung plasma 42" does not power on!!

A computer cord is the same as the original. Go to any Radio Shack or TV shop and ask them to check the fuse to see if it is good or bad. If it is good, then suspect moving damage. If the fuse is bad, the person checking the fuse should be able to suggest a proper replacement. After replacing the fuse ( only if it checked bad), re apply power and hope the set comes on. If the fuse blows a second time, you need to call a technician. One other thing, some sets have a vacation switch that can accidentally get pushed during a move. Consult with the owners manual to verify if your set has one.

Samsung PS42P2S... | Answered on Jan 31, 2008

1 Answer

No indication of power what so ever

Yes, a computer power cord is the same.
Without physical sign of damage, it will be hard to induce the movers to cover the problem. You will need to take it into a reputable TV shop and get their evaluation that whatever is wrong is due to the move. Its odd that it failed while off, however of course all these new TVs are not near as reliable as the old ones. Might just be a dislodged connector inside.
Hope Ya Fix It!

Samsung PS42P2S... | Answered on Jan 24, 2008

1 Answer

No sound or picture

move scart plug a little,sound wire is near end of plug,and sometimes does not connect

Samsung PS42P2S... | Answered on Jan 06, 2008

1 Answer

Erratic samsumg plasma display

yeah the problem maybe that ur power supply is not correct u should drop it off at 10 aston drive bulwell we have the correct supply!!

Samsung PS42P2S... | Answered on Jan 05, 2008

1 Answer

T.v. repair

sounds like a logic main board

Samsung PS42P2S... | Answered on Apr 30, 2007

1 Answer

I have a Samsung un65mu850dfxza fc04 with vertical lines have been appearing intermittently. Everything I have read suggests the Tcon board but I cannot see the part referenced in the schematics.

This tv doesn't have a tcon board.
https://encompass.com/Exploded-View-Assembly/SMG/7120/UN65MU850DFXZA

Samsung... | Answered 3 days ago

1 Answer

My Samsung modelun75ju64. It has half of the screen not showing up properly.

Disconnect from the power for 1 hour. Go to settings - Picture - scroll down to Reset to Factory Defaults.

If that doesn't fix it, look for bad capacitors, or give it to a technician.

Samsung... | Answered on Jan 18, 2021