20 Most Recent Samsung HC-P4241W 42" Rear Projection HDTV-Ready Television Questions & Answers


Was wondering if you got set fixed yet? STK-392-180s are the ics I use when repairing convergence.Replace both chips.

Samsung... | Answered on Nov 30, 2013


usually on your model it might be best to replace the entire deflection board as your model has two STK394-250 ICs and then 12 3.9 ohm fusible resistors that will need to be checked and possibly replaced. If you need further assistance let me know I can assist with getting quality parts and circuit boards.

Samsung... | Answered on Oct 18, 2011


Your Convergence output is burnt.DONT turn that TV on until convergence IC's are replaced,orange glowing inside that you see it is resistors that overheating and burning.Unplug TV from outlet before more damage is done

Samsung... | Answered on Aug 23, 2011


Call Samsung for information 1-800-627-4368
What seems to be your problem with TV?

Samsung... | Answered on Jun 23, 2011


send a email to me at [email protected] I have the diagram for that circuit

Samsung... | Answered on May 04, 2011


double vision with the red and green lights .........how do you change them

Samsung... | Answered on Mar 03, 2011


Your Convergence Ic's need repalced. There are 2 of them and they are soldered in.




crikett_27.jpg

Samsung... | Answered on Feb 04, 2011


Hi

Thanks for using FixYa.The issue is with the failed convergence (STK) ICs which needs to be replaced. It's not a difficult job if you want to do this yourself, you should require some basic knowledge about soldering-resoldering components. To start with you'll have to open the back of the unit and then replace the ICs (STK ICs) which are located behind the black heat sink and also check the resistors as if they are short the ICs might blow again after sometime.
There are repair kits available which includes repair instructions with the parts, if you want to do it yourself, you can buy and repair it yourself. Please rate the solution if the issue is resolved or post a comment for further assistance.

Thanks
Rylee

Samsung... | Answered on Oct 27, 2010


Convergence ICs need to be replaced.
Go to Encompass Parts Distribution 1-800-638-3328
Type in your Model # for Parts List Just replace the whole convergence board ,if you can solder just order STKs big black ICs will have PN# on them. 1-800-628-1118 and sometimes its Faster,Cheaper in the long run.just to replace the whole board.

Samsung... | Answered on Sep 28, 2010


Projection TV sets need to have all three colors - RED - BLUE - GREEN - lined up correctly on the screen in order for the video to look normal. When its out of alignment the video will look 3D, wavy, distorted, etc. Most of the time you just need to adjust your convergence in the TV menu. If you cannot adjust it in the menu - then your convergence is broken and needs to be repaired.
This is a very common failure on these projection sets and a fairly simple DIY fix. All projection sets including Samsung, RCA, Sony, Philip Magnavox, Panasonic, Pioneer, Akai, GE, JVC, Toshiba, and others at some point will have the same problem.
You can get a repair kit with parts and instructions from www.TvRepairKits.com

Samsung... | Answered on Sep 24, 2010


IF YOU HAVE A DVI CONECTER A BIG WHITE PLUG WITH MANY CONNECTERS YOU CAN BUY A HDMI -DVI ADAPTER BESIDE THE DVI CONNECTER YOU WILL HAVE INDICATION FOR DVI AUDIO YOU MUST PASS TWO AUDIO CABLES FOR SOUND

Samsung... | Answered on Jun 03, 2010


Probably only one lamop and that would be the blue

Samsung... | Answered on May 05, 2010


do you smok if yes tack of front panel clean mirror and lense be carful very fragile

Samsung... | Answered on Apr 29, 2010


These sets need to have all three colors - RED - BLUE - GREEN - lined up correctly on the screen in order for the picture to look normal. When its out of alignment the video will look 3-D, wavy, distorted, etc. Most of the time you just need to adjust your convergence in the menu. If you cannot adjust it in the menu - then your convergence is broken and needs to be repaired.

Convergence problems are very common on all Projection TV sets including Sony,Samsung, JVC, Philip Magnavox, Panasonic, Akai, Pioneer, Hitachi, Zenith, and others. You can get a convergenece repair kit wiith instructions from the links below.

Here are some of the most common problems with these sets...

Problem #1) Convergence

Yours may have one or more of the following symptoms
  • Screen Looks 3-D
  • Colors wont align
  • Screen may look distorted or warped
  • No Audio/Video - makes a chirping sound.
Problem #2

Another common problem is dull or washed out video.
Your TV2_bing.gif may have one or more of the following symptoms....
  • Dull looking picture
  • White looking picture
  • Halos around objects
  • Red/Orange looking picture

You can see some more examples and find a fix here
bb0cf99.pnghttp://www.fixya.com/support/r2861467-solution_video_looking_whiteish_dull

Samsung... | Answered on Apr 08, 2010


try vancebaldwin.com if you know what board you need, or pts electronics but you need the part #

Samsung... | Answered on Feb 07, 2010


trye on the netz entrance it is a transformer near high capacity capacitator need to make big swamp of parts there transformer,capacitator,som resistors you need to megje it all that area

Samsung... | Answered on Jan 23, 2010

Not finding what you are looking for?
Samsung HC-P4241W 42" Rear Projection HDTV-Ready Television Logo

56 questions posted

Ask a Question

Usually answered in minutes!

Top Samsung Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76455 Answers

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

 Grubhead
Grubhead

Level 3 Expert

5700 Answers

Are you a Samsung Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Samsung Televison & Video

  • Samsung Televison & Video

Most Popular Question

problems samsung hc p4241w 47 in rear

  • Televison & Video
Loading...