20 Most Recent
Juki 2-Needle Overlock Machine MO-734DE - Page 3 Questions & Answers
Juki 210d error 3
Hi
about error 3 please make sure first dc voltage comining fro power board to servo board check J8,J28, second encoder signal from the motor is not supplied check J2,J29, third check connection between main board and servo board J11,J1
best regards
ashraf
Juki TL 2010Q stopped sewing new out of box
Question moved from Cars and Trucks to Juki Sewing Machine.
I wonder if you mean 'sewing' rather than 'seeing'??
If it is new, did you read all the manual? Did you make sure the leads are nice and tight.
It is under warranty, contact seller or maker.
..
Juki HZL-29Z not stitching!
Question edited for clarity, spelling and capitalization.
Question moved from category 'Cars and Trucks', to Juki sewing machine.
When was the machine last serviced? They should be serviced every 2 or 3 years. Most people never service until they fail and then wonder why they failed.
Slow, weak sewing would be caused by the foot pedal having dirty contacts n the insides. It has a wire wound track and a contact terminal.
The fact the needle doesn't go up and down is either caused by it being in bobbin winding mode, or a link has come off inside.
So first thing to do is open up the foot pedal and clean the contacts with electrical switch cleaner (NOT WD40). Then check you aren't in Bobbin winding mode, normally a clutch on the hand wheel.
Or
Take it to Juki Service.
Videos and the Service Manual in the link
https://www.google.com/search?q=Juki+HZL+29+Service
..
Juki e code 808 solulation ddl8700-7
hello
regarding error code E808 mostly happened in SC-920 control:
1- check +33 DC volt output for thread trimmer - bac-ktack- presser foot lifter.
2- check CTL board. ( any electronic components damage )
the most reason for E808 coming from CTL board.
best regards
ASHRAF ABOZID
[email protected]
Cairo - Egypt
Not finding what you are looking for?