Top 20 Toshiba 32AF41 32" TV Questions & Answers

32AF41 32" TV Manual

Toshiba Televison & Video | Uploaded on Aug 22, 2013

I have a 32af41. Green horizontal retrace lines

These are caused by the ageing of the tube and the final video transistor for the green cathode - the cutout voltage on the final video board is no longer doing its job as the tube heats up so the current passing thru the tube goes up until the X-Ray protection kicks in and cuts the power completely.
Resolder all the components on the video board and try to readjust the cutout voltage - there's a semiadjustable resistor on the video board, right next to the video power transistor - this will give you a few more months of use.

Toshiba 32AF41... | 89 views | 0 helpful votes

1 Answer

Power light is flashing and there is no picture or

Hi Roscoe,

This is an indication of out-of-regulation in the power supply section. The very common caused of this fault is the leaky electrolytic capacitor in that section. It will drop the supply from normal voltage and will disable the unit. Sometimes it has a bulged/dome at the top but not all, it is better that you have a capacitor checker/tester to determine its condition. Also, bad solder joints can produce the same symptom, it is hard to spot, you should use table lamp/portable lamp for finding the cold solder. Secondary reason of fault is the open fuse/fusible resistor in series with the output of regulator IC/transistor, shorted/openRegulator IC/transistor, shorted zener diode(all are in the power supply section) and the microcontroller. Best that you check the output voltage of each regulator to determine where the fault came from and narrow the job.

If you don't have necessary tools and test instruments, and can't do the job yourself, I would advice you to look for a professional to troubleshoot the problem. Don't attempt to work in the power supply if you don't know the safety precaution of handling it, there some stored electricity enough to hurt you with a little mistake only.

Also check if your unit is under warranty /extended warranty, avail it because the manufacturer of your unit will fix it for free. Don't open the back panel, this will void the warranty.

Hope I helped you.

Have a nice day!

Thanks for using Fixya.

Toshiba 32AF41... | 44 views | 0 helpful votes

1 Answer

The screen went from color

Hello there,

That sounds like the TV went to a different input best thing to do here is use the input key on the remote control, if you do not know what input the TV needs to be set too check the back if all the Connections are going to AV1 then you know the input needs to be on AV1 , if you need me to find the input for you i would need more information .

Thank you don't forget to Rate

Toshiba 32AF41... | 27 views | 0 helpful votes

1 Answer

Color problem. No green anymore. What should I

Most of the problems like this is caused by the CRT socket pins needing to be resolderd. There is also a possibility that the CRT it's self could be bad but most of the time it is the socket.
I hope this helps,
skyassoc

Toshiba 32AF41... | 52 views | 0 helpful votes

3 Answers

The screen for my Toshiba

Has anyone had a magnatic or speakers near it? you may just need to demagnatis the TV.

Toshiba 32AF41... | 67 views | 0 helpful votes

1 Answer

After being moved, tv has no color

PROBABLY LOOSE CONNECTIONS FROM THE MOVE. THERE ARE MANY REASONS THESE NTSC TV'S LOOSE COLOR

Toshiba 32AF41... | 53 views | 0 helpful votes

3 Answers

Sound Ok, video OK; except viewing screen is like

I am leaning more of a decoder issue rather then anything else on this particular problem. If this TV is analog witch I think is as I did not see a model number for it what has happened when in 16:9 aspect ratio the decoder is acting up decoder/tuner sorry there one of the same as they both handle signal.

1. check you connections
2. if this is a DVD, blue ray make sure you on the right correct resolution for this TV.

Other then those two issue's I would have it looked at if it is happening only in 16:9 witch is wide screen format usually dvd or High Def. Make sure your TV support high def as well.

Thanks and please click the accept button

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

Toshiba 32AF41... | 69 views | 1 helpful votes

2 Answers

After lightning, my television did not work

Try first leaving the TV power cord unplugged for some times, let say one hour or so.

Also ensure that the fault is not coming from a faulty receiver box sending bad signal, check if you get same problem on dvd with no receiver box connected.

If that does not work, and you keep having a flashing led on front of the TV, and tv turning off by itself after a while, that indicates a fault condition.

The flashing light indicates a diagnostic state called protection.
When the Monitor goes on protection there are only two possible causes.

1The internal circuits are jammed because of electrostatic chargesaccumulating on capacitors, or because of a wrong voltage read by themain chip on your monitor controller board. this started the protectioncircuit.

2 The protection circuit detected a wrong voltage or abroken contact, identified an internal fault and kicked in , startingthe flashing light.

If you are in situation one, then theTV will reset just unplugging power cord for one or two hours,sometimes even minutes.

If you are in situation 2 , then there is an internal fault.

Common faults that can occurr are a blown capacitor on power board, a convergence IC has blown, or a fault on Digital board.

Check also the video cable or any external connection cable, if the cable is shorting, or the connector is bad, you can get same flashing statebecause of the video cable.

Try moving the video cable, and if the cable is not built in, then also try a replacement cable.

If under warranty contact the manufacturer ringing the number on the user manual

If you want to repair at your own expenses, just locate any good qualified repairer.

You can find parts here.

Toshiba 32AF41... | 1,405 views | 3 helpful votes

1 Answer

SAME PROBLEM WITH SAME SET! THIS IS A MANUFACTURES

make sure all other applances are ok not a line buffer are spike problem,maybe too high voltage coming for power company check with meter do you have a lot of bulbs going bad

Toshiba 32AF41... | 136 views | 0 helpful votes

3 Answers

I HAVE A SINOTEC TV

Press and hold down the Music button for about 10 seconds

please rate this solution

Toshiba 32AF41... | 276 views | 5 helpful votes

1 Answer

My rca tv not working

the lamp which you rteplaced is not seated properly.and also it can be the problem of colour wheel or the ballast.to check out all three just check out this links 1 by 1 for colour wheel with diagram and procedure
http://www.jangro.com/a/2006/07/24/samsung-dlp-replace-color-wheel/

for lamp in 5 minutes with diagram and procedure
http://www.jangro.com/a/2006/08/03/how-to-change-your-samsung-dlp-lamp-in-5-minutes

for ballast with diagram and procedure
http://www.consumermeet.com/entry/samsung-dlp-ballast.html

Toshiba 32AF41... | 129 views | 0 helpful votes

1 Answer

TV Stand for Toshiba 32HFX71

Amazon.
Toshiba TV Stand 62HM196

Toshiba 32AF41... | 105 views | 1 helpful votes

1 Answer

Toshiba 27A51 TV won't power up, relay clicks twice

must be some of parts broken down. you have to check powersupply thorougly.

Toshiba 32AF41... | 202 views | 0 helpful votes

1 Answer

My tv is not working

it seems that the Tv sensor (which receives infra red waves from remote control) is not working. you will have replace it.

Toshiba 32AF41... | 62 views | 0 helpful votes

1 Answer

My tv is stuck on

just click the programe button < >

Toshiba 32AF41... | 40 views | 0 helpful votes

1 Answer

Tv no power

It's really not quite enough to go on and could be any of the following; Bad FBT (flyback transformer), R216 in the ABL circuit. (Auto blanking limiter); D404 in the Hv circuit or the HOT (horizontal output transistor) at Q404... I'd start there first and if those test okay then I will dig out the schematics and send you the service manual.
Do you get any relay click when you press power button? That's a TAC0116 chassis and prone to any or all of the above.
Hope this helps!
Bill

William Rayburn, CET
Premium Technologies
PO Box 442
Long Beach, WA. 98631
360-642-4993

Toshiba 32AF41... | 104 views | 0 helpful votes

1 Answer

Rca jacks loose

You may have open the set to reach the rca jack connections. Most probable cause would be loose solder connections. You should do this only if you have experience in electronics, esp. TV circuit boards, otherwise, I would take the set to a service center.

Toshiba 32AF41... | 151 views | 0 helpful votes

1 Answer

Remote control not response from tv

Solder connects IR detector front of chassis,if that does not
do it, replace detector...............................T.

Toshiba 32AF41... | 103 views | 0 helpful votes

2 Answers

No sound from 5 yr old Toshiba

as picture is ok means 100% it is due to sound section. solution 1 check speaker &its connection or loose 2 check supply to sound section 3 check parts in sound section (resistance& capacitors). 4 check for audio ic if it is demaged.

Toshiba 32AF41... | 71 views | 0 helpful votes