Top 20 Toshiba CF35F50 TV Questions & Answers


HiWhen the TV is turned off, try to bump on the two lateral sides with the two hand palms at the same time. If the set comes on, there are dried solder joints that need to be clean and ressoldered. Ressolder all the points where heavy componentes are placed: power switching transformer and switching transistor and flyback transformer and associated circuits and the small pcb attached to the CRT. I do not know why, Toshiba sets are prone to dried solder joinis.Good luck.Sully

Toshiba CF35F50... • 25 views • 0 helpful votes


Hello. Is the line is from left to right or top to bottom

Toshiba CF35F50... • 62 views • 0 helpful votes


Try a different input and see if you get a picture back...try tuner input. A blue screen shows up if it doesn't see an input signal. Try the game on another set. Problem may be with the game.

Toshiba CF35F50... • 71 views • 0 helpful votes


hi, is problably your turner its damage

Toshiba CF35F50... • 76 views • 0 helpful votes


Bad connections in tuner. If your really careful, lots of very small parts, you can resolder the cracked solder ground connections to the metal box and metal shields.

Toshiba CF35F50... • 102 views • 0 helpful votes


Since it is 9 years model definetely loose contact and flux corrosion is there in wire connector and pcb also. Make one general service. Prolem solved.

Toshiba CF35F50... • 136 views • 0 helpful votes


You are missing the red color drive or it is weak. there are adjustments for that in the service menu or on the CRT drive board, but you should not attempt these adjustments unless you have a service manual or know 100% what your doing and how to do them. it could be the picture tube is weak or there could be a problem in the RGB drive circuits. Depending on how old the set is should determine or not it would be worth dropping any cash into it Good Luck

Toshiba CF35F50... • 119 views • 0 helpful votes


The set needs service ,I dont think a new set is the answer a qualified tech should find the problem fast and inexpensibly.Get an estimate.

Toshiba CF35F50... • 105 views • 0 helpful votes


Sounds like some thing short circuit at its circuit board. Short circuit protection activates, as the set is switched on. Contact any service technician to check and find out the fault. This is not a user repairable fault. If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ https://elektrotricks.blogspot.com/ faults & possible causes to LCD screen are given with illustrations. You can get an idea about the fault to an extent. Search the site by type in the brand name and model of your set, in its search bar at the right side column, and press enter.

Toshiba... • 14 views • 0 helpful votes


As long as both TV and DVD player have arc enabled HDMI connections and you enable HDMI-CEC on the TV you should be good to go.

Toshiba... • 21 views • 0 helpful votes


check the tray mostly open close drive motor assembly problem

Toshiba... • 30 views • 0 helpful votes


Yes as long as you have arc-hdmi input on Panasonic TV and arc-hdmi output on Toshiba dvd? If you have these connections then you might need to turn arc and cec on in the settings as by default they could be off.

Toshiba... • 20 views • 0 helpful votes


Take the back off and see if you can see the flat ribbon cables that go into the LCD panel. Apply some pressure on those cables at the place where the line originates from. If that changes the line you know that it is a TAB error. Sometimes applying that pressure is enough to fix it before replacing it.

Toshiba... • 17 views • 0 helpful votes


The CT877 remote was included with several Toshiba TVs, including the 26DF56. Thus the programming codes for the remote are in the TV manual on pages 16-17. This manual is available on the support page: https://support.dynabook.com/support/staticContentDetail?contentId=2844172&isFromTOCLink=false . The current link to the manual is https://content.us.dynabook.com/content/support/manuals/userguides/su2844172/xxdf56_om_e.pdf . It does not have any codes to control other TVs. A universal remote that was programmed six months after your Spectre TV was manufactured would probably be a better solution for you. I hope this helps. Cindy Wells

Toshiba... • 15 views • 0 helpful votes


I think you need to contact there customer support or read the manual.Visit https://www.frogbridgedaycamp.com/

Toshiba... • 14 views • 0 helpful votes


The backlight is probably failing. Replace the backlight if a set is available.

Toshiba... • 17 views • 0 helpful votes


It will only need setting up if the EEPROM has been changed and in that case follow the service instructions. Otherwise the main menu will give aspect ration and tuning adjustments.

Toshiba... • 15 views • 0 helpful votes

Not finding what you are looking for?
Televison & Video Logo

Popular Tags

14 questions posted

Ask a Question

Usually answered in minutes!

Top Toshiba Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76573 Answers

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

matt martin
matt martin

Level 3 Expert

1258 Answers

Are you a Toshiba Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Toshiba Televison & Video

  • Toshiba Televison & Video

Most Popular Question

toshiba cf35f50

  • Televison & Video
Loading...