Top 20
Toshiba 36A43 36" TV Questions & Answers
Free tv repair advice
There are 2 capacitors on the start circuit - 47uF and one 2,2uF, change it then resolder the complete start section and look up for any hair needle crack on the motherboard, resolder the highvoltage transformer too
Red light goes on and off
Needs the button put back into place. Look under the cabinet to see if there is an access panel below the switch, would go for all external controls. There would be a chassis with all the controls mounted to it.Pull the plug before doing any repairs.Look to see what it would look like in it's normal position. Something has moved out of place that holds the switch to the panel. Very tedious if you have to remove the whole housing.
Is it expensive to replace the remote sensor for my Standard Toshiba 36A43 Tv
Remote sensors are very cheap to buy and easy to get device. It is a three solder terminal device.
Visit the site named 'Electro-help' for
more details. Click this link. View it in
"Timeslide" or "Flipcard" option, which can be selected
from the drop down box menu by the [Sidebar] tag, at the top left corner
of the display window. You can also
click the [Home] tab to see the latest updates. It will make search
easy. There are more than 1350 posts to different brand TVs now. Pull up older
posts there or make a search by typing in the brand name of the device in
the "Search Box", at the top right of the display window
Repair manual
If you are saying the cable fitting on the set broke off a cable box with standard audio and video output jacks on the rear can be connected to the same jacks on the rear of the set-----then you select that input (they are numbered) and watch tv using the box for channels.You then have bypassed the tuner connection for the set.
Flashing red light off and on button sound but no picture
If your TV has sound but no picture, start by making sure that all of the set-top box cables and cords are connected and the set-top box is turned on. Also check to see that the TV is set on the correct channel and that the DVD player is not on.If the power light is flashing, it could be excessive or shorted voltage or that the capacitors are malfunctioning. In this case, replacement capacitors or a new power board is in order. Contact a professional for help.If you hear a chirping sound, that is the shutdown circuit activating, indicating a problem with the power supply.For more tips and tricks, check out
No picture on TV for troubleshooting steps and solutions. I hope this helps!
Toshiba 34hfx84 reset
Unplug the TV from AC mains Power Socket, and re-plug it after 15 minutes or so. This must make the TV to a hard reset.
Toshiba 36a43 i have picture but no sound. Volume control works but again still no sound.
Things to check:In menu are speakers (audio area) switched on or off?If you put sound all the way up and listen right at speaker what if anything do you hear?If using a cable or sat box is sound turned down on it?Is sound muted on set or the box (if used)Do you have sound with a DVD etc hooked via the rear jacks?A few sets have a slide switch on the rear= internal or external speakers--is it set to internal?failing all of the above you have a audio circuit problem
Tv wont stop scanning between tv, video1,
Possible there is a sync issue as the return pulses do not come back to lock the scanned channels. This can be an issue which can vary from a simple loose connection to a fault iin the signal processor. This would need the help of a serious probe with a signal tracking using a scope and assisted equipments. Take consensus as this can be tricky before you tamper the board.
Non-responsive to remote, acts like it is in
Your TV needs servicing.You need to open up the control panel and check the buttons for "menu". maybe its stuck inside.some contact cleaner would do the trick. Change the buttons if possible.If symptoms persists than your control IC in the front panel is faulty and needs replacing.Good luck and thanks for using FIXYA.G..
Not finding what you are looking for?