20 Most Recent Aiwa AV-D58 Receiver - Page 5 Questions & Answers

bad power transformer or board

Some guesswork here. If the remote control is specific for the receiver, it should work without any set up required. Just any old Aiwa remote control may not have the necessary code.

It needs cleaning and adjusting. The lubricant has dried out.

check first power supply

Probably something else. The buzzing is typical of an open circuit input "receiving" radiated 50/60 Hz from nearby mains wiring. An alternative source of buzzing is the 50/60 Hz mains breaking through into the audio due to failed smoothing and filtering in the power supply. Capacitors that have been unused for quite a while can lose condition and fail when put into use again and this might have been the cause of the thump/thud/boom you noted. I doubt it is the cause but it is very unwise to operate an amplifier without a full complement of speakers unless the volume is kept at minimum...

The tape player portion is defective, though new. Many of the site moderators have had that experience.

Download a service manual from google.

check more slotjk.com for your solution

You would have to open the unit and check for signal right before headphone plug.

It work as a simple twist action. That small, dark plastic part right in the centre will turn, possible with a small flathead screwdriver.

There's no clear all settings there. You need to manually delete each saved station. Try to unplug the power of the unit for few hours and check if that clears all.

https://www.manualslib.com/manual/3586/Aiwa-Ts-W45.html

Pinterest or utube

https://www.youtube.com/watch?v=xAlPb7NBvz4

How to aiwa nsx t9 in display of

I dont have a remote control

Hi JACQUELYN MOORE, so you say you have problems in the function control system, you might have some of the keys locked and that does not answer any other Check all the keys and see if any are locked and comment Hola JACQUELYN MOORE, por lo que comentas tienes problemas en el sistema de control de funciones, puede ser que tengas alguna de las llaves trabadas y eso hace que no te responda ninguna otra Revisa todas las llaves y ver si alguna esta trabada y comenta https://www.manualslib.com/products/Aiwa-Cx-Zr525-372985.html

I have been having a problem with my above-mentioned turntable. What is happening is that when I load a record onto the platter and press "start" ... questions:if you put the arm on the record without start button,what happens? ... I have a pxe850 in my garage, i think it's a newer equivalent of the pxe800,