20 Most Recent
- Page 8 Questions & Answers
I need the codes for a aiwa stereo
Set-up (Programming) procedure is too much to type in here, and is not practical and it will differ brand-to-brand remote controls. If you wish to get more; check the sites linked here. It has set-up code list & set-up procedure to many popular brand remote controls. One among it has general set-up codes to check with TVs and other devices are given, in the order of the 'device's brand name list' in alphabetical order. Pull up older posts. Search the sites by type in the brand name to your device in its search box at the top right part of the display window. It will help you to find the document easily.....
on Jun 10, 2016
What power source to be used id I am using AIWA PX-E55 as a stand alone unit?
You could probably run it off a large 9 volt battery, as long it doesn't run off a 6 volt supply. How much control of the speed depends on if the deck has inbuilt speed pre-sets to adjust it. In fact that is crucial for any power source that you use. As it will either be too high or low to run the turntable at the correct speed. So if there are no pre-sets on it you will have build that in to the power supply. It all depends on if the original power supply in the unit it was attached to had it controlled from there.
I would have a look at the motor in the deck, it might tell you what it runs on.
Once you find the voltage the motor runs off, you can narrow a suitable power supply down. For example if it ran off a 12 volt supply, you could use a model train set transformer. As basically the motor is nearly the same as train set motor! But must run off about 9 volts that I have seen.
on May 17, 2016
Not finding what you are looking for?