20 Most Recent
Alpine CDA-9811 CD Player Questions & Answers
Make sure you are using the blue/white wire to turn your amp on. The blue wire is antenna remote turn on and turns off when leaving tuner mode. The blue/white wire is amplifier remote turn on.
Alpine CDA-9811...
•
Answered
on Sep 28, 2011
Did you check both the red and yellow wires? You may have a bad connection elsewhere in the vehicle or even bad solder connections inside of the radio itself.
Alpine CDA-9811...
•
Answered
on Jul 08, 2011
push and hold the menu and center button for ten seconds to REFRESH your ipod OR it 's the menu and play button.
Alpine CDA-9811...
•
Answered
on Jan 18, 2011
No, its ok. Try to check the wire connection in the power supply. Check the fuse if the spring that pushes to contact is still working. The problem is on that area.
Alpine CDA-9811...
•
Answered
on Nov 10, 2010
you probably have a bad output ic inside the deck.
Alpine CDA-9811...
•
Answered
on Jun 16, 2010
I would try using a lens cleaner to clean the CD player.
Alpine CDA-9811...
•
Answered
on May 23, 2010
this specific model alpine was famous for that pull the radio out and check the red yellow and black wire were they go into the harness on the back of the radio sometimes the pins in the harness loosen up
Alpine CDA-9811...
•
Answered
on Feb 28, 2010
i have seen the adaptors for most any radio on ebay for that
Alpine CDA-9811...
•
Answered
on Dec 01, 2009
go to the alpine help forum and state your query theyl help you no bother, youl find this forum if you google apline car audio
Alpine CDA-9811...
•
Answered
on Nov 09, 2009
Press "Title" until time is displayed. Then press and hold "Title" for a few seconds until time is displayed. Turn the silver knob to change the hour, after hour is set, press the silver knob to activate minutes. Turn sliver knob to change minutes. Press silver knob to end.
Alpine CDA-9811...
•
Answered
on Oct 20, 2009
you will need an ai-net cable. your local car audio dealer will definitely know.
Alpine CDA-9811...
•
Answered
on Apr 19, 2009
you will need to set up your system to accept aux. default setting is 'aux off'. refer to system manual to setup system to accept 'aux on' on pages 23 & 24. please read carefully as instructions are confusing.
Alpine CDA-9811...
•
Answered
on Apr 19, 2009
you need to set up your system to accept aux. this means you will need to set the 'aux on', as the default setting is 'off'. use the manual and refer to page 23 & 24. please read the instructions carefully, as they are slightly confusing.
Alpine CDA-9811...
•
Answered
on Apr 19, 2009
Not finding what you are looking for?
