20 Most Recent Proficient S12 Subwoofer - Page 8 Questions & Answers


you need to get into the box, and sort all 100 of the cd's out yes all of them..
to this i mean make sure they are in there tray's properly,second make sure the tray's are not "racked",ie that they have not slid out of there small holder's..
now once u have the mean's open the juke box..
find the black switch, pull it out to engage service mode<,
now u go to work on the cd's, then you will hit "h" 0-0 "h"
this should clear your error 73 code ,as long as all the cd's are in there proper place's
press switch back in, you are then back to normal play
at the point of closing the door you might need to power cycle the juke box

Audio Players &... | Answered on Aug 11, 2020


Connect the AUDIO OUT ports on your DVD player to the audio in ports on your TV with the regular or standard audio cables (red and white jacks). Connect the AUDIO OUT ports on your TV to your speakers using a standard audio cable, or a digital audio Optical cable.

Audio Players &... | Answered on Aug 09, 2020


200 watts is the output, home use or commercial? not a good amp to run at its max as it has a low reserve headroom. for home use 100 watts rms is more than enough.

Audio Players &... | Answered on Aug 09, 2020


This is a very common issue. Unplug the mini power jack the thing with the cord. Look inside the chargers hole on the jam box and then take a knife to gently bend the tab back towards the middle or even lower. Be careful when you are re plugging into the power into the socket. The socket tab and the mini plug must meet .

Audio Players &... | Answered on Aug 03, 2020


The AUX connection is what the Line In connection used to be called and generally has a medium impedance and a sensitivity of upwards of 800 mv, often 1 to 1.5 volts, being the typical output of a tuner or tape deck.
Details of this is usually found in the user manual - good matching is repaid in better quality sound and reduced interference.

Audio Players &... | Answered on Aug 02, 2020


The DVD and *and* the DVD player both have a region code embedded in each. A map of the regions used appears below:

steve_con_2.gif

Regions 0, 7, 8 & 9 do not appear as they represent "No Region Coding" "Unused" "Cruise Lines" and "Region Free" respectively.

A DVD player will only play a matching region code DVD, or the player OR DVD have one (or more) 0, 7, 8, or 9 region codes imbedded. You'll not be able to change the DVD code, but you *might* be able to change the region code of your player. Computer DVD players can sometimes be flashed to a new region more readily than the entertainment system DVD players, but it relies solely on the manufacturer and model of the player. Some require file be downloaded and run, while others require a DVD or CD be created and played with a specific file saved on it. Here's a link to results that discuss how to change the region code for DVD players. You'll need to know at the very least the manufacturer and model number of you player to begin.

I hope this helps and good luck! If you found this helpful, please rate my reply 4 "thumbs up". Thanks!

Audio Players &... | Answered on Jul 30, 2020


Press and hold the MFB buttons for about 5 seconds to turn them off. When both earbuds are paired with your cellphone, press and hold the MFB button on either left or right earbud, the other earbuds should turn off at then at the same time.

Audio Players &... | Answered on Jul 29, 2020


The manual has the complete process how to set time.

Audio Players &... | Answered on Jul 22, 2020


A faulty volume potentiometer? Some internal cross-talk? Free wires induction because they are too close, inside? It sounds possible to me and a minor problem. Don't worry too much.

Audio Players &... | Answered on Jul 22, 2020


Usually clocks use the frequency of the AC supply to keep time, a synchronous motor was used in the old motorized clocks. If all the outlets eventually go back to one incoming supply, they all share the same mains frequency.

If it is a quartz reference type, then temperature may be a factor - extremes of temperature will cause deviation in the main oscillator. Otherwise, time appears to be passing at a different rate in that room!

old LED clocks did not have a crystal, they had a counter that counted the 60 cycles power, an intermittent connection will create extra pulses that will be counted. That will make it run fast.

it possible the outlet makes an intermittent connection (loose plug, maybe) so that the clock intermittently switches to battery backup on a lousy quartz crystal timebase that runs too fast during these periods? Remove the battery & see if the clock resets to 12:00 periodically.

Audio Players &... | Answered on Jul 16, 2020


Hi, I finally found a remote for this AC!!!
here is the link https://remotesremade.com/products/replacement-remote-for-carrier-model-40bne

Audio Players &... | Answered on Jul 14, 2020


This speaker is very good.

Audio Players &... | Answered on Jul 06, 2020


Apparental a digital photo frame from 2008, according to an Amazon web site, and is not an audio device:

https://www.amazon.com/-/es/Pandigital-pan1201-W02-12-Inch-Digital-Picture-Frame/dp/B00187AI7E#HLCXComparisonWidget_feature_div

If it is indeed that old, may be unlikely to be worth the cost of repairs unless you can find an identical model to swap parts.

Free online manual for possibly similar model Pan1502 (not 1501) W02:

https://www.manualslib.com/manual/306008/Pandigital-Pan1502w02.html

Audio Players &... | Answered on Jul 05, 2020


I have the service manual for the LT-120 which explains how to do that. There are explanations with diagrams, etc. that won't help without your being able to see them.

Audio Players &... | Answered on Jul 03, 2020


Unknown if the following is the one you were looking for, but link has many manuals which ask for an ES version.

-----------------------------------------------------------------------
http://nsmjukeboxmanuals.yolasite.com/

" Welcome
Here you can find nearly all the NSM jukebox manuals for nearly all the ES- Versions of these fab machines
All you need to know is the ES version of your machine. This is usually printed inside your machine, on the CD player unit or on the record players assembly. Sometimes its printed or stamped into a metal plate by the power lead. It's important you find the correct model and ES version as you can sometimes cause more damage then good!
If you cant find your specific manual try the generic manual for that ES version, this should contain most the stuff you need
"
------------------------------------------------------------------------
http://nsmjukeboxmanuals.yolasite.com/resources/The%20Performer%20Grand%20II.pdf

Audio Players &... | Answered on Jul 02, 2020


My sound don't come out please help my [email protected]
7_1_2020_7_03_37_pm.jpg

Audio Players &... | Answered on Jul 01, 2020


HI I HAVE FIXED THE SAME FAULT ON MY SONY SCANNER BUT NOT FOR THE FAINT HEARTED!. YOU WILL HAVE TO UNSOLDER AND EXTRACT THE CONTROL AS THE TRACK SPRING LEAVES HAVE BECOME WEAK AND ARE NOT TOUCHING THE TRACK PROPERLY.CAREFULLY TAKE APART THE CONTOL CLEAN ANY RESIDUE ON THE TRACK AND CONTACT SPRINGS THEN RE ASSEMBLE AFTER SLIGHTLY BENDING THE CONTACT LEGS TO IMPROVE PRESSURE ON THE TRACK. BEST OF LUCK I HAVE GOT A SPARE WHICH MIGHT FIT YOUR MODEL. CHRIS

Audio Players &... | Answered on Jul 01, 2020

Not finding what you are looking for?
Proficient S12 Subwoofer Logo

13 questions posted

Ask a Question

Usually answered in minutes!

Top Proficient Audio Players & Recorders Experts

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

 Grubhead
Grubhead

Level 3 Expert

5700 Answers

The Knight
The Knight

Level 3 Expert

76466 Answers

Are you a Proficient Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Proficient Audio Players & Recorders

  • Proficient Audio Players & Recorders

Most Popular Question

no get sub

  • Audio Players & Recorders
Loading...