Top 20 Shop Vac 333-32-08 Blower Vac Wet/Dry Vacuum - Page 2 Questions & Answers

Is it new? You know if you don't keep your filter clean and hose cleared of debris they don't last long never run without a bag and or filter unless sucking liquids and liquid only

possible a start/run capacitor failure take it to a vac shop for diagnosis and repair

Contact the manufacturer of device. They may help you. If not, make sure that current is reaching the on/off switch and that the power is reaching the motor - if power gets to motor and still nada then the issue is probably with the brushes not making proper contact with the commutator.

Contact the company you placed the order with and explain it to them.

connect the hose on the other end where it say vacuum not blow.

doesnt really matter. however to be safe, I would wire Blue as the hot switch lead and brown to the neutral side.

this video mite help you

Amazon is your best bet. Type in 120 volt rocker switch

From what I have heard, the switch on these units can sometimes be defective. Also, looking closely at the the AC cord may help determine if there is damage to it that should be repaired.

try this link below http://www.retrevo.com/search?q=Shop-Vac+9625510&st=20

Fill it up with hot hot hot water

Shop vacs are multiple purpose with dry/wet intake. So typically you don't need a bag. You just open the tank and empty it like a big trash can. They will have a large filter In the tank that needs to be cleaned/replaced.

Best thing you can do is pull the other three off and throw em away or else glue them on the wheels being detachable means they get lost every time

Replace If you need further help, I’m available over the phone at https://www.6ya.com/expert/ron_a476a70a75690d24

It is possible that the dust chute on the Kobalt saw is plugged, not allowing the vacuum to pick up the dust. Run a rod through the dust tube and see if that clears it.

If new filter doesn't do it, then check hose for debris I’m happy to assist further over the phone at https://www.6ya.com/expert/matt_0c9009be7d775298

The hole behind the saw blade can become blocked solid with sawdust ( especially if the timber is green or wet). clean out the vacuum hose back to the collector.

And so do they all shop vac decibels sound level Bing images

You have two options: return it to seller or put the information about the model number and name in your search spot and Google for manual.

Yes, in one way the suction would be higher, but there would now be an additional load on the motor. Also, it would have more suction, but less volume (air flow).