Top 20 Canon ImageRunner 3320N Copier Questions & Answers

what machine.

it may be because of dirty laser unit or the iptics.try cleaning the optics and then the fuser.charging can also be a problem .check DP unit for toner layer .

take out a internal report on A4 .if it ok then the problem is from optics and u have to clean it .if the report is also faded then the laser unit is dirty so u have to take it out if ur a rep and clean it with simple white cloth for dust on mirrors

FUSER UNIT STUCKED REMOVE & CLEAN IT OR FIXING MOTOR REPLACED

YOUR MACHINE HARDIDSK HAS CRASHED .TRY PRESSING 1 & 9 AND THEN POWER ON THE MACHINE WITH 1&9 PRESSED .iT WILL DE FRAGMENT THE HARD DRIVE BUT EVENTUALLY U HAVE A TO GET A NEW ONE OTHERWISE THE ERROR WILL COME AGAIN

THIS IS A HIGH VOLTAGE ERROR.FOR RECTIFYING THIS FIRST BRING BACK THE VALUES OF DEVELOP IN SERVICE MODE BACK TO NORMAL.CLEAN THE DRUM UNIT.

Do you have the install disk? If not, you can go to hp.com. Drivers and downloads. If there are any updates for windows 7, they'll be there. if you have already done this, then answer me back exactly what happens.

Let me know

Hey!On the panel should be a button with a (123)on it!Press that and it will give you the meter reading!!Good Luck!

it is in the copier settings. one is actually set up to automaticly do doublesided copies as a default. while the other one is only set up to do singlesided copies

first while on the main copy screen change the setting how you want the copier setup ..... double sided printing, black and white, or how ever you want your defaults to be set up

then you will need to goto the additional functions button and under copy settings you will need scroll down to the second page.

there you will want to hit the standard setting button then click the store button, then click yes... now it will default to the double sided copies.....


hopefully this will fix the problem if not get back to me

try to set the toner a few times more, this error code is developer trouble.So it could be that toner isnt recognized, not properly inserted, or you have some tape leftovers on toner, or you have broken developer unit, or ...

you need to place new toner on top of toner unit, press it until cliks and you pull the plastick "track" out do not tear it.

you push in on the front top where the stop strip was and it will pop up unless you have yet to add toner to the developing hoppper then you would fallow the directions on the toner box

replace the black drum

Try canonusa.com and look under image runners for your model. Hope this helps.

Reader / scanner assy communication error, check all leads and switch back on.

I've seen this problem quite frequently if its the same thing. I've seen alot of times when running on 11 by 17 smudging through the print mostly near the corners. You may need to adjust the fuser roller speed and the vertical transport speed which is in level 2 of service software. If this sounds like your problem let me know and I can walk you through the adjustment.

you also have to high lite service mode and clear that or the error will return

Every new unit comes with the user's manuals, and every new unit has free tech support from the vendor. What you are looking for is under the "System Settings" found after pressing "Additional Functions".

Try using the roller cleaning or wire cleaning procedure in additional functions. If fault persists, it might be toner build up on the fuser roller from dots worn onto the surface on the fuser rollers.