20 Most Recent Canon Image Runner 3320I Copier Questions & Answers

i believe you add them in under the additional fuctions menu. and have to select address book there and program them in

1- Open The Front door,2- disengage developer unit (DP),3- down the feeder using green handle,4- remove screw of drum unit,5- pull out the drum unit6- empty the waste toner removing with white strip.

cleen the waste toner sanser

e602-001/002/003/004 solution is turn off the machine after than
1-9 key hold & machine on 1 hour raning after same time display sow the downlod mode thn machine off/on

e019-0000 cleen the west tank

Hello,
this is error for waste toner, and the waste toner needs to be cleaned.

On left sideway of copier, in lower left corner you will see the plastic cover with one screw.

Remove the plastic cover and remove waste toner box by pulling toward you. Empty it and clean the neck of the bottle. Put it back in and restart copier,

Hope that helps!

how can i solve error code E000003-0000

NO 1 MIRROR DETECTING ERROR CHECK SENSOR AND CORRECT IT.

Error code 60 means the changing roller is not being detected position it properly. check if it is not in a pool of toner if so clean the toner properly with dry clothe.
Error 007 means the fixing fume is not being detected because it is damage and needs to be replaced.

that is the usually about toner.
several possibility :
- motor of box toner does not working, so the toner can not move down to developer.
- sensor of toner at the box has loosen. (can not detect the toner)

Hello,
the error code for full waste toner is E019. To solve the problem, as you know, you need to clean/empty the waste toner box.
To do these:

On left side way of copier, in lower left angle, there is plastic cover with one screw. Unscrew and remove the plastic cover, then pull out to remove waste toner box. Empty it! With piece of clothe, clean the "neck" of the bottle, because on round inserts on neck, is where the sensor reads the FULL or OK state.
Put it back in and turn off and on the copier.

Hope that helps!

Hello,
on back side of the copier are small black switch, it is protective fuse. Try to put him back ON.
If these doesn't helps you have power supply problem....

Keep me posted!

Hope that helps!