Top 20 Howard Miller Greer Chiming Quartz Wall Clock Questions & Answers

In a quartz movement clock, with a problem like this, the chime box (or whole movement) will need to be replaced. Timesavers.con carries a large selection of chiming quarts movements.

Howard Miller... | 436 views | 0 helpful votes

Clock oil, and a very small drop on each bushing, and pivot not on the gears in between the plates. Do not get oil on the hair spring if it has a balance wheel escapement. After oiling it's good to wiggle each gear back and forth to work the oil in. Good Luck in your adventure.

Howard Miller... | 445 views | 0 helpful votes

replace the battery

Home | 19 views | 0 helpful votes

I am no expert on such matters but I hear it isn't easy even with modern radar and satellite observation though of course much depends on the size of the vessel, the construction and the range you wish to track it as well as whether you are fixed or mobile and your elevation.

The best way is to place a radio beacon aboard and have at least three listening stations equipped with direction-finding receiving equipment.

Home | 18 views | 0 helpful votes

The chirp is typically a low battery indicator. It can also mean End Of Life.

If its disconnected and no battery but still chirps, press/hold the test button to discharge residual power.

Home | 17 views | 0 helpful votes

maybe you could get the fire dept to come by and test for high co levels. sounds to me like you need to

Home | 17 views | 0 helpful votes

with a voltage tester aka multimeter set to dc volts

Home | 15 views | 0 helpful votes

check the battery is in there correctly. if the detector is more than 10 years old replace it

Home | 14 views | 0 helpful votes

Find the Trouble and stop it. Find the Fire and put it out.

contact the maker of your mystery device

Home | 18 views | 3 helpful votes

I would suggest you ONLY DO THIS when the stove is COLD! Always Use Safety Gloves when touching a Stove.
Some stoves have a "Lift and Swing" latch where you use a handle to slide the door up a short amount then swing it outwards.
Others have a "Slide" latch where you slide a peg or handle across a slot to unlock the doors.
Another version of this can be a 'twist' instead of a slide.

Home | 14 views | 0 helpful votes

Breville is no longer viable.

Home | 20 views | 0 helpful votes

The "plumber" who did the original installation may have used undersized pipe or failed to flush the fixtures. Another possibility is the fixtures are inadequate for the intended use. Your new home warranty is valid for a limited time so the second plumber is letting the clock run out. You may wind up paying out of pocket to have a real plumber get things straightened out.

Home | 12 views | 0 helpful votes

Try to remove batteries and set clock again. Last night was time change and maybe that is the reason.

Home | 14 views | 0 helpful votes

Try a simple solution first. Spray the key hole and the door mechanism with a good amount of light spray oil. Then operate the key and locking mechanism 10 to 15 times to spread the oil around the parts inside. This should act as a lubricant and an light antifreeze.

Home | 14 views | 0 helpful votes

Not finding what you are looking for?
Howard Miller Greer Chiming Quartz Wall Clock Logo

1 questions posted

Ask a Question

Usually answered in minutes!

Top Howard Miller Home Experts

john h

Level 3 Expert

23504 Answers

Tom Chichester

Level 3 Expert

60258 Answers

Brad Brown

Level 3 Expert

18520 Answers

Are you a Howard Miller Home Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Howard Miller Home

  • Howard Miller Home

Most Popular Question

clock chimes correct amount chimes all

  • Home