20 Most Recent
Maxent MX-26X3 Television Questions & Answers
The TV doesn't power up
If power reaching unit and after all you have checked, it appears the PS is fubar. Easiest thing to do is check for swollen/leaking/blown capacitors and replace them - cross your fingers and turn on.
How can i fix static on my maxent lcd tv
26 inch maxent mx-26x3 and 32 inch, l2614xw02 some same parts When i hear the word static, i think snow,If while your watching tv and it looks like color snow pixels popping in and out all over the picture i did this to fix it.look at main board you see a green heat sink,left of that heat sink you see a 220 uf 16 volt capacitor that half surround by 22 uf capacitors,change the 220 uf capacitor and snow is gone.to get it off i just wiggle slowly back in forth until the old capacitor falls off,then put some fresh solder on and new capacitor on and done.use a radial electrolytic capacitor not the little metal one they had ontc bagabillion
Maxent mx-26x3 video issue
The tv probably does'nt have a fast enough refresh rate to work with games properly. It should be in the manual for the tv, the lower the number the better. I think it's 12 milliseconds on that tv. Have a look here:
Response Rates.
Dark area on screen.
i have had the same problem with the dark patch and found out it was because i had a speaker sat too close to the tv!!!
Maxent MX-26X3 picture problem
someone gave me a maxent mx26x3 with the same problem. I took the back cover off, and then the metal shield covering the PC board. There is a green heat sink on the main processing chip. The heat sink was not making good contact. I slightly twisted and pushed the heatsink on the the chip, and the picture stayed perfect now for 2 days. I think the heatsink will eventually need to be re-glued on with thermal expoy glue. It will be a pain to remove and clean though.
Maxnet mx-26x3 tv toconnect toan HDMI input
Maxent ,mx 26 x3 turns on for 5sc.( all white) then picture flickers and screen goes black.. green light on throughout..none of button on the remote or the tv will work expect the power .i wonder is their a way to reset the tv?
Can I use this as a PC monitor via adapters of
yes you can and fromwhat i see you have the right connection on the monitor so you dont need any special adapters - you just need a 15pin VGA cable with audio (mini phono for audio) male for all connections on both sides of wire
connector should look like this
wire should look lilke this
hope this helps
good luck!!
Maxent MX-26X3
More than probably is the LCD control board, but this one is coming with the LCD panel. Could be the main PCB too and I suggest you to call a tech for a exact diagnosys because the parts implied are very expansive.
Not finding what you are looking for?