20 Most Recent JVC MX-D301T Shelf System - Page 5 Questions & Answers

In my experience the JVC brand hasn't maintained it's early promise of quality and I avoid the brand these days. It would have been helpful if you described the noise and mentioned whether it was constant on both FM and AM. Excessive noise isn't unusual on AM due to the inability of the basic circuitry to reject the various sources of interference found in the average home, partly because the AM ferrite rod antenna is usually inside the radio. The average AM radio is highly receptive to receiving and amplifying lots of interference from many sources especially that radiated by fluorescent lighting, cfl bulbs and even nearby mains wiring resulting in a loud hum or buzz. With the high popularity of FM and the introduction of DAB that has increasing popularity, the development of AM receivers ceased several decades ago. FM is immune from that type of interference but is by no means able to reject all interference and a powerful signal from an external antenna produces the best result, the best signal to noise ratio. Assuming the radio isn't faulty, the problem is most likely interference. If the power cord has a ground conductor it is very important it is connected to a good electrically quiet ground. If this isn't possible it could improve things to use an independent ground to the outer conductor of the coax cable to the FM antenna.

Type: auto reverse, double compact cassette deck

Track System: 4-track, 2-channel stereo

Tape Speed: 4.8 cm/s

Heads: 1 x record/playback, 1 x playback, 1 x erase

Motor: 1 x capstan, 1 x reel, 1 x mechanism

Tape Type: type I, CrO2, Metal

Noise Reduction: B, C

Headroom Extension: HX Pro

Frequency Response: 20Hz to 17kHz (Metal tape)

Signal to Noise Ratio: 73dB (dolby C)

Wow and Flutter: 0.08%

Total Harmonic Distortion: 0.8%

Input: 80mV (line)

Output: 300V (line)

Dimensions: 435 x 133 x 328mm

Weight: 4.9kg

A fan is not running

Seek tech support.

I searched jvc.com for your model CA-C77BK S/N and couldn't find it even in the archives.

It must be a discontinued unit.

Usually when this happens you have to take the unit apart to retrieve the cd.

I don't think it's worth fixing, as parts don't seem to be available or listed, not even the user's manual online at jvc.com.

However, I did find a link for the service manual for this vintage compact component system:
http://www.vintagemanuals.com/manual.php?manufacturer=JVC&model=CA-C77BK%2C+CA-C99

May I refer you to that manual to try to figure out how to fix this problem.

Unfortunately, it costs $33 for the manual. You'll have to decide if it is worth it to buy it.

Good luck to you in fixing this problem.

Hi hope this helps. ....cheers

Hi Honwani, indicates model of the JVC team you are commenting on, in order to find the best possible solution I wait your answer Regards Franco Dosil Hola Honwani, indica modelo del equipo JVC del que estas comentando, para poder encontrar la mejor soluci?n posible Espero tu respuesta Saludos Franco Dosil

Hi Leonard Oliver, what are you needing a JVC tape player ?, indicates the model I wait your answer Regards Franco Dosil Hola Leonard Oliver, que estas necesitando de un reproductor de cintas JVC?, indica el modelo Espero tu respuesta Saludos Franco Dosil

Hello Paul, what you have found is a cassette recorder rewriter of two mechanisms, commonly called "Double Cassette" to be able to listen or record, you would have to connect it to an amplifier that has a Tape input You can not connect directly to the speakers, unless the speakers have their own amplifier, if so, you would need a cable from two RCA to two RCA I hope you serve my comment Greetings Franco Dosil Hola Paul, lo que has encontrado es un reproductor grabador de cassette de dos mecanismos, com?nmente llamado "Doble Cassettera" para poder escuchar o grabar, tendr?as que conectarlo a un amplificador que tenga entrada de Tape No puedes conectarle directamente a los parlante, salvo que los parlantes, tengan amplificador propio, si fuera as?, necesitar?as un cable de dos RCA a dos RCA Espero te sirva mi comentario Saludos Franco Dosil

Go to the speaker selector and set it tonone or headphones... Good luck!

Hello Velile, indicate the model of your Home Theater JVC, to find the best possible solution Try disconnecting your JVC from the socket, then check that the cables that go to the speakers are well, that they are not peeled or shorted, after checking, reconnect and see if you are still in Protect If you continue in Protect, I suggest you contact a specialized technical service I hope you can solve the problem Greetings Franco Dosil Hola Velile, indica el modelo de tu Home Theater JVC, para poder encontrar la mejor soluci?n posible Prueba desconectar tu JVC del toma de corriente, luego revisa que los cables que van hacia los parlantes se encuentren bien, que no se encuentren pelados o en cortocircuito, despu?s de revisar, vuelve a conectar y f?jate si sigue en Protect Si continua en Protect, te sugiero te contactes con un servicio t?cnico especializado Espero Puedas resolver el problema Saludos Franco Dosil

Hi Mark, so you account for your JVC, you are not reading the CD, should you indicate on the display, "NO DISC", have you tried to clean the lens of the laser reader, with a cotton swab with a little alcohol? Another possibility would be that you had, low emission of the reader, which could be adjusted, using the necessary instruments If after cleaning the reader, it does not work, I suggest you look for a specialized technical service I hope to solve the problem Greetings Franco Dosil Hola Mark, por lo que cuentas tu JVC, no esta leyendo el CD, deber?a indicarte en el display, "NO DISC", has probado limpiar la lente del lector l?ser, con un hisopo de algod?n con un poquito de alcohol? Otra posibilidad seria que tuvieras, baja emisi?n del lector, el cual se podr?a ajustar, utilizando el instrumental necesario Si despu?s de limpiar el lector, no funciono, te sugiero que busques un servicio t?cnico especializado Espero logres resolver el problema Saludos Franco Dosil https://elektrotanya.com/jvc_fs-d88.pdf/download.html https://www.manualslib.com/products/Jvc-Ux-D88-4185098.html

its lens not working..which is inside... change it.

Unplug the unit for a minute or two then plug it in and try opening again. If that doesn't work try taping on the door while pressing the 'open' button.

Hello Clyde, you can connect your EQ2 to the JVC RX 8000v I sent you the user manual of the JVC RX 8000v to guide you you have to connect it as if it were a cassette From the Rec Out of the Cover or MD, in the JVC to the equalizer line input and the equalizer line output to Play In in the JVC this you can see on page 6 I hope you get it connected Greetings Franco Dosil Hola Clyde, puedes conectar tu EQ2 en el JVC RX 8000v te envio el manual de usuario del JVC RX 8000v para que te guies tienes que conectarlo como si fuera una cassettera Del Rec Out de Tapa o MD, en el JVC a la entrada de linea del ecualizador y de la salida de linea del ecualizador a Play In en el JVC esto lo puedes ver en la pagina 6 Espero que logres conectarlo Saludos Franco Dosil https://www.manualslib.com/manual/83906/Jvc-Rx-8000vbk.html

Sorry, no. You must have the JVC MX-DK1 Upgrade disc to be able to upgrade.

USE PEEL REMOTE ON A SMARTPHONE. ONCE WORKING YOU CAN COPY TO A UNIVERSAL PROGRAMMABLE REMOTE. QED.