20 Most Recent
Mintek MDP-1770 Portable DVD Player - Page 9 Questions & Answers
A DVD is stuck inside the TV
Do not touch any components on the circuit board. Remove jewelry, wear safety glasses and gloves. Remove all the screws from the back with an arrow pointing to them and any screws on the bottom holding the PC board in. Discharge the tube if it is a CRT by grounding a screwdriver to the chassis ground with a clip lead. Slide the screwdriver under the "suction cup" on the tube with the large red wire coming out. Disconnect all the connectors from the PC board and write down how to reconnect. Slide out the PC board and retrieve the disc from the DVD mechanism. Reassemble
I need a battery charger/ac adapter for a
Hi...
If you want to buy a battery charger and AC adapter you buy that online. Go to ebay website that is an online selling website.
www,ebay.com
Good luck!
ICmanServer
When disc is loaded, it stays on loading and
Sounds like the laser has developed a fault, first i would try cleaning the laser lens with a CD / DVD Cleaning disk and if that fails , open it up and using a Q-tip and methylated spirits , dab a small bit of Meths on the cotton tip and in a circular motion clean the laser eye gently But Make sure it is unplugged, if that fails you will need a new laser lens.
hope this at least helps.
jon
I have a Mintek 2580
The default code to unlock parental control on this model is 88888. Are you able to enter it from the front controls? If so, it should work.
I have a Mintek portable
So you need a power adapter? And other cords that come with it? correct?
Thanks, looking into it.
Have a Mintek 1070 MDP
You need to clean the device using compressed air first and then a disk DVD cleaning kit(any walmart etc.). Hopefully the laser just has some debris on it that is preventing it from reading the disk. Open the dvd tray and use the compressed air to blow out the interior. Taking the device apart is not necessary. Then try using the DVD player cleaning kit. Hopefully this will help.
I have a mintek 10.2"
all DVD player has the same problem, it is the lens cable to the
circuit board or the DVD PCB needs to be changed. Try to see if the
lens cables has any bends or bend out leads and try replacing the
cable to see it is the problem. If its not the case than definately
the DVD PCB board needs to be replaced.
Shows no disk
dear lyndamesa,
If your cd s damaged then u your player shows no disk option. so jus check it up withnew cd. still prob exists, then your lens has been damaged. so u should change the lens.
Cable connection
If the threaded co-axial connection (which is what its called) has come off your tv, you'll have to take it in for service. Many TV/VCR repair shops can solder a new one on for less than 80 bucks.
Steven
I own a Mintek
uses 9 volt 2 amp positive in in center connector so get a universal
Not finding what you are looking for?