JVC RX-6018V Receiver - Answered Questions & Fixed issues


you can do it a couple of different ways, depending on what you're trying to do with your set-up.if you're trying to do something different than what I describe here, add a comment. for independent volume control (each unit contols volume to a set of speakers independent of each other) use the rca 'tape' out of the jvc into the rca inputs on the back of the gemini.this puts a stereo signal from the jvc to the gemini. if you want your gemini to power your subs, get an rca y-splitter (single female to double male) and a single rca cable, hook single rca cable to sub out of jvc, connect y-splitter to gemini rca inputs, and single rca to y-splitter.

JVC RX-6018V... • Answered on Mar 06, 2013 • 241 views


The nature of a source's digital bitstream is automatically detected at the receiver. Look at your unidentified source and ITS manual for that answer.

http://www.retrevo.com/support/JVC-RX-6018VBKJ-Receivers-manual/id/315ag011/t/2/

See the box on page 14.

JVC RX-6018V... • Answered on Sep 23, 2011 • 249 views


Generally speaking, an amp attempts to protect itself from heat, shorts, overloads and operator exuberance by refusing to turn on or stay on.

Overloads can be from excessive periods of high output or marginally low impedance loading by the speakers; and shorts would be wiring issues or a speaker blowing up.

You should be able to feel if it's hot. WHY is it overheating? Make sure it has sufficient ventilation on all sides and that vent holes are not blocked by dust balls. Ensure the fan (if equipped) is running as designed (some only operate on demand). Clean dust and debris from it.

If the amp comes back on after cooling, you're lucky. They only have so many self-protection cycles in their lives so continuously resetting or cycling their power without addressing the cause can do more harm than good.

If it protects immediately on a cool power up you should disconnect the speaker connections and try it 'naked'. If it comes up then diagnose which lead(s) are shorted. If it does not come up the problem is internal and should be left to an experienced and competent hands-on tech.

JVC RX-6018V... • Answered on May 29, 2011 • 76 views


You should try pressing the surround on/off button or the speakers on/off button

JVC RX-6018V... • Answered on Feb 27, 2011 • 183 views


you need to perform this ...one end of the jack is on the input of your unit and the opposite end try to touch if there is hum ..set a maximum volume..to hear it better...if there is sound your unit is good..if without,your input is deffective..make sure that our jack is good.

JVC RX-6018V... • Answered on Sep 06, 2010 • 198 views


If you get your system up and running and hear an audible buzz or hum, the first culprit to look at is either the powered subwoofer or your reciever feed at the entry point to your system.



JVC RX-6018V... • Answered on Dec 23, 2009 • 355 views


Do you have too much of a load on the amplifier? Or as SallieJohns mentioned, is it getting adequate ventilation?

JVC RX-6018V... • Answered on Oct 18, 2013 • 408 views


No, one of your speakers is damaged (could be an amp channel went bad, but speaker is more likely). Unplug all spkrs, then plug one in and see if it acts normal when turned up. Repeat this until all speakers are hooked up or the culprit spkr is found.

JVC RX-6018V... • Answered on Jan 14, 2008 • 472 views


Did you check impedance value and wattage on speakers you want to add to receiver?

JVC RX-6018V... • Answered on Oct 03, 2007 • 328 views


Try first to disconnect all of your speaker wires and turn back on this receiver. If the problem persists, you will need to take the unit into a shop and have the output circuits checked out, as these are all solid state parts that are soldered into the printed circuit boards and there are no user replaceable parts inside this receiver. Good Luck

JVC RX-6018V... • Answered on Dec 25, 2007 • 460 views


Change your Home Station in the DAB settings. If you do that and it reverts back, there _may_ be a motherboard battery that needs replacing. It is losing its memory when it is turned off. https://www.manualslib.com/manual/1366367/Jvc-Ux-D150.html ..

JVC Audio... • Answered on Feb 09, 2021 • 18 views


First, contact Bell and inquire whether their remote control contains the appropriate code.

JVC Audio... • Answered on Jan 10, 2021 • 20 views


Contact JVC to request.

JVC Audio... • Answered on Jan 03, 2021 • 121 views


Request the manual directly from JVC.

JVC Audio... • Answered on Jan 03, 2021 • 124 views


Order the service manual from JVC.

JVC Audio... • Answered on Jan 02, 2021 • 100 views


Find the components that failed and replace them.

JVC Audio... • Answered on Dec 01, 2020 • 126 views


1. Open internal fuse 2. Open power switch 3. Power supply failure

JVC Audio... • Answered on Nov 29, 2020 • 49 views

Not finding what you are looking for?
JVC RX-6018V Receiver Logo

Popular Tags

23 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top JVC Audio Players & Recorders Experts

The Knight
The Knight

Level 3 Expert

76584 Answers

xxxxxx xxx

Level 3 Expert

5023 Answers

Cindy Wells

Level 3 Expert

6259 Answers

Are you a JVC Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...