20 Most Recent Crate CA6110DG Gunnison Acoustic Guitar Amplifier - Page 3 Questions & Answers

The easiest way would be to contact Crate customer service, or Guitar Center, or Musician's Friend, or Ebay.Here are the links- http://www.crateamps.com/support/index.php Guitar Center Music Instruments Accessories and Equipment Musician Friend Musical Instruments Store eBayeBay

Perhaps these loinks will help- 25 000 terabytes of music videos and posts http://www.crateamps.com/support

Amps have fuses inside. Check them if they are blown. After replacing, if it keeps blowing, then you have a short that needs to be fixed. Good luck!

Most likely a loose connection. Try to tighten the knobs and the cord port to the crate. You need to do this from the inside. These tend to loosen with use and anything that is connected with them will also loosen, like the electrical connections. Good luck!

Hi, you hadnt mentioned how long you've had the amp, or how new it is, so I'm going to assume it's new to you. The Crate VTX200 has 3 channels, each with its own volume level. Let's check the simple things first: 1. Check to make sure you're adjusting the same volume knob volume knob to the same channel. The active channel will be lit with a green light. 2. Check the cables from the "Speaker Out" jacks on the amp (if you are using them). Are they plugged in all the way, or are they damaged? 3. Are you playing through a preset that you may have accidentally made "low", and may not be aware of or are stuck in it? If none of these answers helps, there might be a problem with the input buffer in the circuit or possibly within the damping circuit of the speakers. I'd advise having the amp serviced to confirm an internal electrical problem also. If you don't have a manual for the amp, one can be found here: http://www.manualguru.com/crate-amplifiers/vtx200/users-manual

Without hearing it in action, it's hard to pinpoint a problem. It could be as simple as a dirty jack, or it could be components overheating, or something else entirly. I'd take it to the repair shop.

If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/

Your best bet would be ebay.

If u can bend the 2 prongs back towards plug end it. Will work on prong rides on tip of it the second rides in between the to nylon rings on it if that doesn't work any radio shack carry it for about 1-2 dollars

Hello Jamie. Your right, it is not rocket science, this is way bigger and funnier! Now, that you took apart the chasis fron the cabinet, you may try testing if the channel switching occurs when you hit the Printed Circuit board with some tool like the handle of a screwdriver. you can try with light hits and different places of the PCB while watching what happens in the front panel light. also you can try bending the PCB with your hand to see what happens, if the switching occurs, maybe you have a cracked solder on the pedal jack or in any component related to the switching circuit, in this case, you will have to pull out the pcb, and re-solder those points that can be cracked. Using a magnifiying glass is very helpful in looking for those cracked solders. Good luck and best wishes.

need model number, manufaturer, just like a car..

is this a loud tech speaker or SLM speaker?

because something in it is shorted..shop time.

did it blow a fuse or is it just dead?