20 Most Recent
Rockford Fosgate Punch 500a2 Car Audio Amplifier - Page 6 Questions & Answers
Rattling in a P3
yes you have burnt the coil up the rattling you here is the loose wire
RF p2d2 12 smoking
you cooked the coil in the sub when you see smoke you have clipped the sub. improper wiring probably the issue ohms must match gain must be set properly . if you had gain all the way up thats what did it.
At high levels sounds more like a thump than boom
Make sure the GAIN on the amp is not all the way up it is not a loud button. your amp should be tuned to your subs with the GAIN or on some LEVEL. if they are not matched you will clip the amp and subs and blow them.Is it in the proper sized box? is the amp able to run the sub at the ohm it needs to be run at and do you have the the ohm load correct on the sub. there is a lot to it. if your not familiar with it go to youtube and watch some videos there is some good vids there and will help you learn to wire a sub correctly i have enclosed a link easy to use.
Rockford Fosgate Woofer WiringWizard
Can I wire two p3 12 Rockford fosgate subs to a kicker 250.1 amp
It has two speaker terminals which allows you to wire muliple subs to the amp easier than trying to cram the wires all into one set of terminals. The two sets of terminals are wire in parallel internally on the amp, so it matters no which + or - you use on it. However, you need to remember they are already wired in parallel internally, so if you were to wire up two 2 ohm subs, the amp would see a 1 ohm load (which it's not stable at), not a 2 ohm.
Not finding what you are looking for?
