20 Most Recent
Rockford Fosgate Punch P5002 Car Audio Amplifier - Page 8 Questions & Answers
RF p2d2 12 smoking
you cooked the coil in the sub when you see smoke you have clipped the sub. improper wiring probably the issue ohms must match gain must be set properly . if you had gain all the way up thats what did it.
At high levels sounds more like a thump than boom
Make sure the GAIN on the amp is not all the way up it is not a loud button. your amp should be tuned to your subs with the GAIN or on some LEVEL. if they are not matched you will clip the amp and subs and blow them.Is it in the proper sized box? is the amp able to run the sub at the ohm it needs to be run at and do you have the the ohm load correct on the sub. there is a lot to it. if your not familiar with it go to youtube and watch some videos there is some good vids there and will help you learn to wire a sub correctly i have enclosed a link easy to use.
Rockford Fosgate Woofer WiringWizard
Can I wire two p3 12 Rockford fosgate subs to a kicker 250.1 amp
It has two speaker terminals which allows you to wire muliple subs to the amp easier than trying to cram the wires all into one set of terminals. The two sets of terminals are wire in parallel internally on the amp, so it matters no which + or - you use on it. However, you need to remember they are already wired in parallel internally, so if you were to wire up two 2 ohm subs, the amp would see a 1 ohm load (which it's not stable at), not a 2 ohm.
Wires on my amp touched now its not turning on and
Disconnect all speaker connections and rca cables. Leave power, ground and remote wires intact. Try turning on again. If you still have a protection light your amp is faulty. Hopefully you have warranty. Your amp is clipping. Double check all connec
.A thumbs up would be greatly appreciated if this answer is helpful to you.
1992 Rockford Fosgate Power 100HD transistors
they are gone gone long gone there is no information about it
i remember 15 years ago having the same problem with the 100 hd and the 75 hd
call fosgate they fax me the schematic showing the modification
how to use different transistors and a new resistor have to be replace for each transistor
good luck
save that amplifier i have mine in the close-tt
I have a Punch 150
call rockford and send it back for a replacement. These amps have some problems
Not finding what you are looking for?
