20 Most Recent
Brother DCP-310CN All-In-One InkJet Printer - Page 2 Questions & Answers
DCP-J315W shows "Unable to Init 4F"
Turn off the printer and unplug it from the power. Then press and hold the power button for 1 minute. Now release the button, plug in the printer and turn it on and see if the error clears.
If it doesn't fix the issue, you probably have to replace the cartridges. They will cost about $65. Good luck!
PRINT BECAME VERY LIGHT,HOW TO IMPROVE?
change new toner cartridge or good quality toner for better image.also before refilling make sure remove old toner from the cartridge and clean inside the cartridge with blower. you will get with a good quality image
I have a brothermfc 7340 printer and cannot replace the drum
Open the front of the printer by pulling the front panel toward you and down. (where you replace the toner cartridge)Remove the toner cartridge/drum unit assembly by pulling up and toward you.separate the drum unit from the toner cartridge by pressing the green release tab on the side and lifting them apart.place the toner cartridge into the new drum unitreplace back in the printerpress "clear/back" button and then press "1" to cancel "replace drum" messageclose the front panel.http://support.brother.com/g/b/faqend.aspx?c=au&lang=en&prod=mfc7340_us_as&faqid=faq00000154_039
MY BROTHER PRINTER 4F
Hi Anonymous.
The 4F error is related to a failed printhead.
In the case of this new printer coming up with a 4F error it can be one of two things.
1) The printer had a faulty printhead straight out of box. Not common but can happen.
2) You have pushed your printer too hard. Normally Brother Inkjet printers are not designed to handle 2000 page print jobs (That is 4 reams of paper) most inkjet printers don't even have close to enough ink to do this sort of print job. You may have just blown the printhead up through overuse.
Not finding what you are looking for?