20 Most Recent
Zenith XBR413 DVD Recorder - Page 2 Questions & Answers
Record vcr to dvd-r
This suggests that you are net setting up the DVD recorder up correctly,
Check- are you connecting to the correct 'INPUT; port?
Check have you select the correct chanell that points to this port.
Carefully go the the book- vey can be very dense to read.
Zenith XVB422 DVD VCR comb
Hi skielty58...I just saw your post, so I haven't done any research yet. However, IF should you see this post prior to my, or any other contributors forthcoming updates which should contain a certain resolution, I would like you to try something during the interim.
Play a dvd, and although showing the blue screen, allow to play for about a minute. Now, using your remote, press and release STOP, and within 1 second, Press And Hold Stop for 10 to 15 seconds. This trick is reliant upon the timing sequence, so, you may want to try it more than once. Another trick that I'd like to suggest is that again, after allowing a dvd to play for a minute, simultaneously press select and stop on the player...Please update your post whether positive or negative so other potential contributors have the benefit of ongoing history...good luck my friend
Zenith xbr413
remove the cover to make sure that there is nothing in the vcr. if nothing in in it then you either have broken gears or more likely your gear are out of alignment. if out of alignment, best to have a service manual handy to figure out the timming of the gears.
good luck.
My zenith CD/DVD duplicator LCD light on but no ready
If the LCD light on your Zenith CD/DVD duplicator is on but it is not showing as "ready," it is possible that there is an issue with the duplicator's internal components or settings. Here are a few troubleshooting steps you can take to try and resolve the issue:
Check the disc trays: Make sure that all of the disc trays are closed properly and that there are no discs stuck inside the duplicator. If a tray is open or a disc is stuck, the duplicator will not be able to operate properly.
Check the power source: Make sure that the duplicator is plugged into a working power source and that the power cable is securely connected to the duplicator. If the power source is not providing enough power, the duplicator may not be able to operate.
Check the settings: Check the duplicator's settings to ensure that it is set up correctly for the type of disc you are trying to duplicate. For example, if you are trying to duplicate a DVD, make sure that the duplicator is set to duplicate DVDs and not CDs.
Reset the duplicator: Try resetting the duplicator by unplugging it from the power source for a few minutes, then plugging it back in and turning it on. This can sometimes resolve minor issues with the duplicator's internal components.
If none of these steps resolve the issue, it is possible that there is a more serious issue with the duplicator's hardware or software. In this case, it may be best to contact Zenith customer support or a professional technician for further assistance.
Not finding what you are looking for?