20 Most Recent Zenith D52WLCD 52" Rear Projection HDTV-Ready Television Questions & Answers


It is in the manual. Or call Zenith Tech support.

Zenith D52WLCD... | Answered on Nov 14, 2013


is the red gone on all inputs? do you have the tv hooked up, to a sat box, cable box via component video (Red, blue, green connections)? if so check the red cable on both ends.

Zenith D52WLCD... | Answered on Jun 20, 2013


If its possible you will need to locate a service manual to do it---a reset is available only on some sets and will not cure screen defects---only thing I have encountered is if it has one--it will correct communication issues between the engine and main chassis.

Zenith D52WLCD... | Answered on Dec 08, 2012


REPLACE BULB AND PUT IT BACK IN, AND IT WONT COME ON... WHAT SHALL I DO

Zenith D52WLCD... | Answered on Nov 23, 2012


Replace it. It is not worth the approx $600.00 to repair, new 46" LCD flat go for less then that. Check Costco and Best Buy have great prices. Also the color and clarity of the newer flats is far superior to any rear projection.

Zenith D52WLCD... | Answered on Jan 19, 2012


The cost to repair (about $600) this problem will be close to the cost to replace it. I advise you to look for one of the new LCD flat screens, a 46 inch can be had for about $500 if you watch the sales.

Zenith D52WLCD... | Answered on Jan 19, 2012


No,the tv message said replace lamp wright?Yes,mean the tv projection lamp is the causes and the problems.The tv projection lamp life span have ended that why the tv it is not holding a stable tv projection lamp picture.All throught these causes,does the tv make alot of clicking noises too,when the tv projection lamp is it on for 30 sec.and shut it self off?Yes,than the board that call the Ballast board it is also dead too.This Ballast board only job are to ignite the tv projection lamp only.Tries websites like Partstore.com,Ebay.com to buy a new tv projection lamp and a new Ballast board too for the replament too,if this tv causes have alot of clicking noises,when the tv is trying to ignite the tv projection lamp.

Zenith D52WLCD... | Answered on Aug 09, 2011


Try this. Type in the model number on Amazon. That is where o ordered mine

Zenith D52WLCD... | Answered on Jul 23, 2011


Hi,

Yes, the procedure you've entered, pressing the "?" key at the remote control at standby mode, follow by pressing 9,8,7,6 is correct to reset the lamp timer.

Another is by pressing and holding the "Menu" key at the remote control until the "OSD" (on screen display) menu disappears follow by pressing 9,8,7,6.

If the unit still keeps turning off, let me know which led light(Operation, Lamp, temperature) at the front panel lit solid/blink and its color to determine where the fault came from.

Jdvillanueva

Zenith D52WLCD... | Answered on Jul 18, 2011


try this if you have the remote control, press the menu button continuously, The "OSD" menus will disappear then press the "9876" and press the "OK" button to enter "ADJ" mode you will see "Lamp Life Time" Then set the time to "00".

Zenith D52WLCD... | Answered on Jun 12, 2011


it sounds like you have a light engine problem with your unit possibly a lcd plate issue if you have it under a extended warranty id call for service if not look for a light engine replacement

Zenith D52WLCD... | Answered on Jun 05, 2011


Your power supply is failing. Seek out a television repair shop in your local area.

Zenith D52WLCD... | Answered on May 04, 2011


usually that means the bulb for the projector is out there usually around 100 dollars! it could also mean the color board is out. so open it up look for the bulb if it looks blown then just buy the bulb and you got a nice tv if not junk it!

Zenith D52WLCD... | Answered on Mar 26, 2011


convergence settings buddy normal tv repair for under 100 dollars its a normal thing should be adjusted every 3 years but some tvs can last 10 years or even longer or sometimes less than 3 years its just your luck

Zenith D52WLCD... | Answered on Mar 10, 2011

Not finding what you are looking for?
Zenith D52WLCD 52" Rear Projection HDTV-Ready Television Logo

Popular Tags

152 questions posted

Ask a Question

Usually answered in minutes!

Top Zenith Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76204 Answers

matt martin
matt martin

Level 3 Expert

1257 Answers

 Grubhead
Grubhead

Level 3 Expert

5699 Answers

Are you a Zenith Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Zenith Televison & Video

  • Zenith Televison & Video

Most Popular Question

someone from townhouse put

  • Televison & Video
Loading...