20 Most Recent Durabrand DB1200 CD Player - Page 2 Questions & Answers

best place to check is any car audio stores close to u they normally have generic and universal wire harnesses

I have a db 1210 and i need the wireing plug for the speakers can you help

yes u can still get the wiring harness from durabrand products i just received mine today. Call 1-866-626-7863 and order it cost was $22.00 shipped. Ken

i had this happen, a cd was stuck in it

Sorry, face will cost you more than the radio did...installed!
Good Luck (try Pioneer next time)

send me a self addressed prepaid envelope and ill send you the one i have and not going to use. email me for my [email protected]

I found a sticker in the documentation. It came with my RV, and was hidden under a drawer.

you can find the diagram at www.installer.com

The yellow wire is probably connected to a power wire that switches off with the car. It needs to be moved to a constant power wire, as it is the wire that keeps the memory powered even while the car is off.

Press the Disp button. Release it. Press and hold it for 2 seconds. It will start flashing. Then press Tune >> and Tune << to adjust the time.

You can get Replacement Wiring Harnesses from the Durabrand Website under Parts. Or Check out Crutchfield.com and see if they have a Replacement. Go to the Customer Service Part. Please Rate My Response! Thanks!

According to the manual er-3 is a "Servo error or the disc is in upside down". I wish i were kidding but that is what the manual says.

I still have my manual I discovered it yesterday. I unfortunetely don't have a place to host it, but if you email me at [email protected] with subject "manual request", I will email it too you.

I have the original manual, but no place to host it. If you email me at [email protected] with subject "manual request" i will email it to you.

Ok everyone,

If your looking for an answer for this I hope this helps.

The connector on the back of the Duraband receiver is the same design as the connector used on
most computer power supply connectors for the motherboard.

You can cut off the old connector for the PC power supply, and then cut off as many extra pins as
needed so it will fit into the back of the receiver.

Only thing is you will need to re-label each wire according to your old harness that may be damaged.
If ANYONE has the existing harness, and would like to tell us which pin goes to which color, this would be great. Most of the receivers have a color code on the case bottom, but it doesn't identify which color corresponds to which pin... please help...

Randy

burning to fast maby try updating software u burn with use nero

what does it say on the screen?

Mark
www.blueice-electronics.co.uk

Go to duraband.com they have the user manual in pdf format and it shows you the wiring scheme.