20 Most Recent
- Page 5 Questions & Answers
I need help to clear error 18 on konical minolta 240f.
Konica Minolta bizhub 240F Error Codes
Quoting from the web link shown above:
Konica-Minolta bizhub 240F Error Codes
Exploded Views and Parts List Free!
(The number indicates the detailed error code) 0 The fuser did not become to the main motor driving temperature in 50 seconds after printing started. 1 The fuser did not become to the paper pick-up temperature in 50 seconds after printing started. 2 The fuser did not become to the main motor driving temperature in 30 seconds after warming up started. 3 The fuser did not become to the warm-up finishing temperature in 30 seconds after the motor started driving. 4 A temperature of 250°C or higher is detected in a mode other than sleep mode. 5 The fuser does not warm after fuser error is solved and the power is turned OFF/ON. 6 A low temperature of 10°C is detected in 10 seconds after printing started. 7 A temperature of 190°C is detected in ready mode after printing finished.
1. Turn on the power again, and verify the fuser warms up. If it does not, see step 4. 2. Check the contact between Fusing thermistor and Connect A PCB(P89). 3. Check the contact between Connect A PCB (P80C) and the main board. 4. Replace the Fuser. 5. After replacing the Fuser, verify the fuser warms up when the power is on. 6. Replace the main control PCB.
Minolta c650 code P22
Clean the sensors under the transfer belt, the black drum recommended be replaced. Since Black is what all the colors are aligned to. To clean sensor requires removal of the Transfer belt be careful as any damage to the belt will result in copy quality issues Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f
Respectd,sir my di520 minolta machine error c-0510 i check the thermistor ,fusior not damage pleses guaide .
FIRST, if this code comes back. Have a technician look at it DO NOT CONTINUE TO RESET the code!!!! AS this is for the Hot Part called the FUSER. It can catch on fire! And that will ruin a perfectly good day!!!!
Open the front door of the copier, copier must be on. Look to your upper left, you should see a small cover with a screw remove and the cover. Inside you will see a small button, press it that should reset the copier. AGAIN if this code comes back. Have a technician look at it DO NOT CONTINUE TO RESET the code!!!! AS this is for the Hot Part called the FUSER. It can catch on fire! And that will ruin a perfectly good day!!!! Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f
ERROR C-2703 IN KONI
KA MINOLTA BIZHUB PRESS C1060
Check the charge Corona Assy unit for cyan (Blue) Open front covers Pull out mid section NOT paper section (have to unscrew two screw to open this section one to the left of the unit the other upper left just below the control panel. Should see four devices that look like they could be pulled out with your thumb. one each for each drum pull them out check that the very thin wire below the grid is not broken the re-seat each one check the all might as well. Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f
Not finding what you are looking for?