20 Most Recent
Minolta magicolor 2350 Laser Printer - Page 8 Questions & Answers
Minolta c650 code P22
Clean the sensors under the transfer belt, the black drum recommended be replaced. Since Black is what all the colors are aligned to. To clean sensor requires removal of the Transfer belt be careful as any damage to the belt will result in copy quality issues Btw, I’m available to help over the phone in case u need at
https://www.6ya.com/expert/normanj_7893313f0751935f
Respectd,sir my di520 minolta machine error c-0510 i check the thermistor ,fusior not damage pleses guaide .
FIRST, if this code comes back. Have a technician look at it DO NOT CONTINUE TO RESET the code!!!! AS this is for the Hot Part called the FUSER. It can catch on fire! And that will ruin a perfectly good day!!!!
Open the front door of the copier, copier must be on. Look to your upper left, you should see a small cover with a screw remove and the cover. Inside you will see a small button, press it that should reset the copier. AGAIN if this code comes back. Have a technician look at it DO NOT CONTINUE TO RESET the code!!!! AS this is for the Hot Part called the FUSER. It can catch on fire! And that will ruin a perfectly good day!!!! Btw, I’m available to help over the phone in case u need at
https://www.6ya.com/expert/normanj_7893313f0751935f
ERROR C-2703 IN KONI
KA MINOLTA BIZHUB PRESS C1060
Check the charge Corona Assy unit for cyan (Blue) Open front covers Pull out mid section NOT paper section (have to unscrew two screw to open this section one to the left of the unit the other upper left just below the control panel. Should see four devices that look like they could be pulled out with your thumb. one each for each drum pull them out check that the very thin wire below the grid is not broken the re-seat each one check the all might as well. Btw, I’m available to help over the phone in case u need at
https://www.6ya.com/expert/normanj_7893313f0751935f
HELP! Minolta Dialta Di350 Showing Error Code C0F35
Well the C0F35 is because there is no toner in the image unit so replace the image unit. just buy a whole new unit. as for the c0070 try this
Power off the machine. Then remove the toner bottle, be careful the hole might be on the bottom and the toner is going to go everywhere. Then close the toner cover and turn on the machine. Let the machine go through it normal routine. When it asks for toner install the toner bottle correctly. If THE KNUB on the side of the bottle is damage put a new one in. That KNUB is what the toner motor uses to turn the bottle, if it damaged you get a code. If that does not work, you might have a bad motor or the home sensor or actuator for the toner bottle is bad worse case the control board is bad. Btw, I’m available to help over the phone in case u need at
https://www.6ya.com/expert/normanj_7893313f0751935f
Not finding what you are looking for?