Rangemaster Broan 614804 BALLISTA 48IN HOOD1 BRAND IN STOCK - Answered Questions & Fixed issues


May I get the make and model # so i can get you the install manual

Rangemaster... | Answered on Jul 22, 2015 | 391 views


This sound like the pcb for all your cooker hood spares visit our site

You-Tube video "8eLuShj-RAg" placeholder (do not delete)

Rangemaster... | Answered on Jul 07, 2015 | 1,048 views


this sound like the pcb for all your cooker hood spares visit our site

You-Tube video "8eLuShj-RAg" placeholder (do not delete)

Rangemaster... | Answered on Jan 08, 2010 | 1,729 views


hood should be connected to a fused spur outlet which you havent found. try removing the chimney and you may find it there. chimney only held by 2 screws at top usually.the fuse in the outlet sometimes goes when bulbs blow

Rangemaster... | Answered on Jun 03, 2007 | 1,094 views


To access AVG support centre, just dial 1-877-916-7666. Your call is answered by our qualified engineer without any delay. This toll free service remains open on a 24X7 basis.

Rangemaster... | Answered on Dec 18, 2019 | 100 views


Check for a controller board. Probably that or a temp sensor.

Rangemaster... | Answered on Jan 18, 2019 | 95 views


Could be a broken resistance. Good luck.

Rangemaster... | Answered on Jan 08, 2019 | 73 views


I’d be looking at wiring both in Stove and house. If that’s not comfortable to you, call repair tech or electrician

Rangemaster... | Answered on Oct 31, 2018 | 55 views


Thanks for your post! I believe there are many who feel the same satisfaction as I read this article! I hope you will continue to have such articles to share with everyone!
If you require Geek Squad Protection visit https://geeksquadprotectionplan.net/

Rangemaster... | Answered on Oct 13, 2018 | 61 views


Check your circuit breakers for a kitchen circuit that is off. Most range hoods are wired to a different circuit than the cooktop/range. Next check if any nearby GFCI (ground fault) or AFCI (arc fault) outlets aren't working. If the outlets have test/reset buttons, try to reset them. Warning: if these repeatedly trip, there may be a leak getting to your wiring (GFCI) or an insulation problem or loose wire that is causing a potential fire risk. Alternatively the outlets could be damaged and need to be replaced.

I hope this helps.

Cindy Wells
(My range hood is wired to a lighting circuit. Thus it's not on a GFCI circuit. However, your wiring could be different.)

Rangemaster... | Answered on Sep 14, 2018 | 56 views


belling induction top on belling electric coocker ER47 error code. none of the plates work,

Rangemaster... | Answered on Aug 02, 2018 | 1,171 views


Most likely you need to remove burner caps and clean out holes. While it is off turn it on for a sec and see if you small gas. CAREFUL just a sec.
A good cleaning is best before you call your gas company. Our's PG&E do'es it for free check with yours before you call a repairman.

Hope this helps Mike

Rangemaster... | Answered on May 31, 2018 | 48 views


due to safety issues - and possibly injury from a hot burner when you think it is turned off - talk to a local repairman in your area.

Rangemaster... | Answered on Mar 26, 2018 | 38 views


First, I'm not a Rangemaster Tech.
* call vendor for service. Gas leaks are hazardous and require a qualified tech to service.
*** The following is for information only.***
* I've always had problems servicing gas stove, heaters, boilers, etc. Lots of unique components that require special tools to service.
* I was surprised to find out that it's better to call on your local Gas Supplier for service. The not only check the supply line but also have a very good working experience with all types of gas fired equipment.
* Slow pilot lighting or burner fire usually means a clogged gas vent or valve. If other burners are working fine, then it's just that particular burner.
* If all burners have the same symptom then it could be a number of things.
* Check gas mains for pressure and flow (you need a gas meter for this but if you have another stove on the same line then it's probable that the mains are okay. Unless the connector or shutoff valve is not working properly (partial open).
* Check gas hose to stove for kinks. Replace if bent (re bending will crack a metal hose.)
* Check the gas regulator (again, need a gas meter)
* Check the feed and branches for gas. If pilot lights are not on then there is a good indication that your not getting gas to that section. (or the pilot is clogged) Clean, clear, or replace pipes/parts.
* Check valve on each burner. This is the most used item on the stove. Expect it to wear out. Replace as needed.
* Final, Be safe; Call your Gas company or MFR tech for service.
Aloha, ukeboy57

Rangemaster... | Answered on Mar 12, 2018 | 49 views


Hi Anita,
I am not shure, but do this cooker have already flame faillure device?
In that case I thnk this is the problem.
If not, it is a clogged nozzle.
You can remove that nozzle, that is under the burnercap, with a 7 mm wrench. Then clean it so you can see trough it and put it back.
They look like the ones in the link.

RANGEMASTER Oven Cooker Natural Gas to LPG Conversion Nozzle Kit A027639...

Have a nice weekend, Dik

Rangemaster... | Answered on Feb 17, 2018 | 56 views


Hi Cindy,
Next link gives you where you can buy a new one and the last picture shows you the back side.
There are 2 pins that go through the plate and then it has 2 special clamps. You can remove these carefully with a little screwdriver and a pair of pliers. Be carefully not to distroy these clamps.
Rangemaster 5925 110 Electric White Brass Name Badge

Have a good weekend, Dik

Rangemaster... | Answered on Feb 17, 2018 | 45 views

Not finding what you are looking for?
Rangemaster Broan 614804 BALLISTA 48IN HOOD1 BRAND IN STOCK Logo

9 questions posted

Ask a Question

Usually answered in minutes!

Top Rangemaster Kitchen Ranges Experts

Paul Carew

Level 3 Expert

3524 Answers

jdthefixer

Level 3 Expert

747 Answers

john h

Level 3 Expert

23438 Answers

Are you a Rangemaster Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...