20 Most Recent
Questions & Answers
Continuous red light blinking, no display
These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices.
Pyle pld3mu wont read disc
probably bad disc or possibly you used wrong screws in side of unit that went in to far and are blocking cd to operate properly
Why wont my Pyle PLD3MU car radio read disc?
Maybe it need a cleaning service. Firsth clean the laser lenss very carefully and after the mechanism complete. If the problem is not solved, possibly the optical pickup laser is damaged and need to be replaced.
AVIC-N1 wont read navigation disc
If your error message is reading "insert appropriate disk" or "inappropriate disk inserted" than I have the solution. Can you just let me know exactly what the message is?
Avic-N1 touch screen calibration...
1. Take disc out.
2. Press and hold eject and push the reset button. (don't release
the eject button 'till screen closes and opens again.
3. Sceen will ask you to push reset.(don't)
4. With right knob... up,up,down,down,push
5. Perform steeps 1,2,3,and 4 only:
The first outlines the screen
The second has you push hash marks
The third verifys
The fourth Saves
6. Use "Band" buton for "back"
7. Press reset
I have a pioneer avic-ni
Common failure on these units is the flex cable. Contact Pioneer and send it to them for service. Last I heard they were not suppling this part.
Not finding what you are looking for?