Top 20 OKI MICROLINE 320 Turbo Matrix Printer Questions & Answers

Is this a networked printer? You may need to reload the print driver into your computers. Most printers are generic enough that computers will recognize them and automatically install the drivers. Sometimes you need to go to the manufacturer's website and download the drivers you need.

Unplug the network cable and restart the printer. If it sits there doing nothing then the PC's job that you sent to it is the problem. If however the printer although unplugged from network starts printing again then yes the printer memory is messed up and you will need a new main pcb as you cant clear its memory as its integral with the board.

Well it sounds like the old inverter had a problem with regulation and it has inturn blown the power supplies in both printers. Without buying new PSU's there is nothing you can do. The Switch-mode power supplies in most printers do not like unstable input and that is what your inverter gave them.

need more info. is it hooked up usb or parallel? Are you printing from windows or like an AS400 or OS X. What error is the alarm light blinking or just stays on?.

Remove the plastic shield on the ribbon, you may get a bit of ribbon rub, but it's normally not noticeable.

Its more likely that the problem is cheap ribbons or old ribbons as they dry out with age.

Sounds like the media detect sensor is jammed or broken. Remove the platen and check underneath to make sure a label has become stuck over the sensor which would trick the printer into thinking it always has media.

Check your printer driver and the communication cable. These are the two most common causes of this issue.

http://www.fastprinters.com

try with just off and and on can helps or remove usb cord and then plug again in some case windows need restart

Most likely a bad printhead

you can download the driver from here:http://my.okidata.com/pp-ML320Turbo.nsf/openingdrivermenu?OpenFrameSetgo to above site and click on your operating system ,then you can download driver.

It needs cleaning and allignment.

do you use tractor paper or plain sheets,if tractor and rear feed gear is engaged and sensor does not see that it is and is then by default it would try to print as on sheets but actually prints on tractor paper

Hi,you can download drivers for your printer from this website:http://www.tvs-e.in/product.aspx?pid=12

Have you contacted OKI Data? Live customer support is available 24/7 (within the US and Canada) at 1-800-OKI-DATA.

Clean or replace the printing head.

have you tried cleaning printhead easy two screw comes out ribbon cable off soak in isopropenol will clean jets out

Hi,Check the paper paths for any stuck papers and remove them manually.Clear any print queues.Make sure the printer is set as the default printer.Uninstall and reinstall the printer.Problem solved?Try changing the printer cable.Hope this helps.Thanks!