Top 20 Pioneer DEH-P6600 CD Player Questions & Answers

make sure ur antenna's hooked up

Error codes 12 and 17 are for a dirty or scratched disc. First thing to try would be a different disc. If this does not work most higher-end pioneer head units have a software reset button which is not well marked but usually located behind the face plate and you can use a pen or a pin to push this. It needs to be held down for a few seconds and this will reset all of the settings to factory standard. This does mean that you will lose all saved radio stations, clock settings, audio settings etc. If it still wont play any discs after that it will likely need more detailed attention from a technician. Cheers, Dan

1. • Turn the stereo off by pressing the "source" button on the bottom left corner of the stereo's face. Press the "function" button, the lower of the two buttons to the right of the stereo display, until the clock appears on the display. Press the arrow keys at the far right of the stereo's face to adjust the time. Use the left or right arrows to toggle between hours and minutes. Use the up and down arrow to increase or decrease the hour or minute numbers. Press the "function" button once you have set the display clock to the correct time.
     

Source- http://www.ehow.com/how_6881633_do-pioneer-deh_p6600-cd-player_.html

The following figure should be able to help you out.

Heres the manual - http://caraudio.manualsonline.com/manuals/mfg/pioneer/dehp6600.html

This is directly from the installation manual from pioneer website for model DEH-P6600

(Yellow/black
If you use a cellular telephone, connect it via the
Audio Mute lead on the cellular telephone. If not,
keep the Audio Mute lead free of any connections.)

Basically, you don't hook it up unles you have a cellular telephone in your vehicle, not a personal cell phone.

You need an adapter for a double din to a single din radio. You can get these at almost any place that sells car audio. Yours is a common adapter they are about $15.

If its a aftermarket stereo, the red wire is ignition, yellow wire is constant 12 volts, & black wire is ground. The speaker wires should be purple + & purple w/ black stripe - / white + & white w/ black stripe - / green + & w/ black stripe - / gray + w/ black stripe - /....then blue is for power antenna. Thats most aftermarket radios, some have orange for a dimmer but it depends on the brand.

start with a 12 volt light tester or you can just run new ones from your fuse box

is the image set up on demo, or random scroll thru the image menu and set it up as you prefer, that should stop the ever-changing imagery

Pioneer authorized service center.
CLICK HERE to find the one nearest you.

Thanks for using FixYa

http://www.pioneerelectronics.com/pio/pe/images/portal/cit_11221/58651943OPERATION%20MANUAL%20DEH-P6600%2020040225.pdf

The contacts on the faceplate or radio are dirty. Remove the faceplate and thoroughly clean the copper contacts with wet Q-tips in alcohol. Also clean the ones on the radio.

press function to select clock
press function repeatedly until clock appears on display
press < or > arrows to select part of clock to adjust
press Up or Down arrows to change hour/minute

Here is the address link for a download for your exact owners manual:

http://www.pioneerelectronics.com/PUSA/Unassigned+Content/ci.OPERATION+MANUAL+DEH-P6600+20040225.Protected

Remove the speakers and trace the signal pairs (wires) to their origin, maybe they are still factory harnessed where you can access a connection point behind the head unit. Here are the factory color codes .

Hope this helps
Aduz

JEEP P o w e r Memory (+12v Constant) Pink Ignition (+12v Switched) Violet/White Ground (-) Black Illumination Orange Dimmer Blue/White Power Antenna
S p e a k e r s Right Front (+) White Right Front (-) Black Left Front (+) Green Left Front (-) Black/Yellow Right Rear (+) White/Black Right Rear (-) Brown Left Rear (+) Green/White Left Rear (-) Brown/White

had the same problem with a pioneer i took a qtip and some rubbing alcohol and cleaned the gold colored connecters on the face and radio and worked ever sine.

set ur stereo to play sound the the rear left then try the wires when u hear sound you know thats the rear left wires, then do right front etc etc, the colours will be in pairs like gray then gray with black line would be 1 speaker

if you still have that deh-p6600 faceplate i'll buy it from you

yes they are the same radio 1 is just premier brand pioneer

Turn the radio off. Press and hold the #5. Then do it with the #6. Turn the radio back on and you should be good.