Pioneer DEH-P9600MP CD Player - Answered Questions & Fixed issues

yes it is a over heting problem

sounds like you have a bad flexible cable. in my shop it would be about a 50.00 repair. i don't know what other places would charge.

try pacparts.com

pull the unit out and make sure that your connections are all good and solid -if you wiggled it and it worked momentarily- then chances are the wiring or wiring harness is loose and needs some attention

I have the same deck. replace the flex ribbon to sub panel. It's a problem with this deck. I've replaced the rear panel ribbon numerous times as well as the front panel ribbon.

YOU NEED TO REPLACE A RIBBON CABLE CALL 1 800 421 5080 IS A COMPANY NAMED PACIFIC PARTS THEY SELL THAT PART.

first check all of your power and ground connections and be sure your battery is good then try the small reset button on the front face. if that does not work you may need a new flexible ribbon cable that you can find on ebay cheap.

you need a new flexable ribbon cable. try ebay or pacparts.com

try pacparts.com

no i havnt found the problem yet but my brother who repairs electronics will be back from australia in the nex few days ill run it past him thanks steve

I had load of these units and the cure is simple. You need to replace the ribbon to the faceplate as these get damaged due to wear and tear. Every unit i had with this fault, i fixed by replacing this ribbon. Buy the ribbon and surround as the new surround is a modified one to give extra life to the ribbon. Hope this helps, good luck!

An install gone bad. Something is hindering free movement of the face plate open mechanism. Closely inspect the top edge of the bezel, is the face plate trim ( thin plastic ornamental frame covering the ugly aluminium mounting sleeve) snapped securely back in place? has it been fitted upside down?, is it deformed?.

to the battery

find an unused or broken stereo, and use the one off it

my 9600 gat the same problem.. been told the ribbon needs replacing they sell on ebay for about £30 or you can send ur h/u to pioneer to do but that will be more expensive..

hope this helps

make sure our face plate goes in good snap in take a q-tip clean contact from radio to face plate hope its that cheers

get a new ribbon from Pioneer

When the unit was in the Mazda, it was run and monitored by the Body Control Module computer. Moving dedicated units from one vehicle to another seldom works the way you expect. https://www.google.com/search?q=pioneer+ca9pa+v6+650+wiring+diagram ..

Four wires ... which four wires.

See page 37 of manual. Procedure is given there. AVH-601EX_600EX_501EX_500EX_OpManual062918.pdf (pioneerelectronics.com)