How do I reset my Pioneer VSX 932?
While holding down [AUTO/DIRECT] on the main unit, press [STANDBY/ON] on the main unit. 2. "Clear" appears on the display and the unit returns to standby. Do not unplug the power cord until "Clear" disappears from the display.
Mar. 11, 2019
Pioneer Elite SC-91 Manual Online: using all zone standby, Setting The Switching Time For The Receiver Operation Mode, Resetting The Remote Control ...
PDF
Increase the separation between the equipment and receiver. - Connect the ... Using the SR+ mode with a Pioneer flat panel TV . ... Plug the power cable into the AC outlet and switch on the receiver.1 Make ... See Automatically setting up for surround sound (MCACC ... 4 Optical and coaxial digital audio inputs (x7 (SC-07),.
PDF
The STANDBY/ON switch on this unit will not completely shut off all ... Plugging in the receiver . ... Automatically conducting optimum sound tuning (Full Auto MCACC) . ... Setting the switching time of AV amplifier operation mode. ... On a Mac, launch Safari and click <SC-85> displayed in 'Bonjour' on the Bookmarks bar.
PDF
Before plugging in for the first time, read the following ... The STANDBY/ON switch on this unit will not ... Connecting a satellite/cable receiver or other set-top box . ... Switching on/off the Acoustic Calibration EQ, Auto Sound Retriever or Dialog ... For the SC-65, the optional AS-BT200 Bluetooth adapter works together with ...
Check to see that the A/C power cord is plugged into the electrical outlet and the power on the unit is turned "On" if the receiver will not power up. Test another appliance in the same outlet to check that it is "hot." Check the household fuse box for blown fuses and tripped breakers. Reset breakers and replace blown fuses with others of the exact same rating. If you are using the remote control, check the batteries and replace them, if necessary. As a last measure, remove the power cord from the electrical outlet and then reconnect it to try and reset the system.
The diagram that I looked at real fast did not have a lot of detail. There are filter circuits in that unit to keep the sub woofer channel in a specific range and there are circuits called op amps that drive those filters. You could have a bad filter component or a failed OP amp. IT will take special equipment to find and replace the bad part. IT could be a weak soldering connection also.
Your Pioneer unit has gone into protect mode because of component failure. Use your multimeter to check continuity and voltages at the component level. Also check for cold solder joints.
