20 Most Recent Technics SA-EX320 Receiver Questions & Answers


Disconnect the speaker wires at the receiver, turn up the volume, if it goes into protection, it's an internal problem and needs service. If it does not go into protection, re connect one speaker at a time and test. If it shuts down check the speaker itself, if they are as old as the receiver, chances are good that the surrounds on the speakers themselves have disintegrated. Older speakers used foam surrounds, newer ones use rubber or plastic composite material that will not disintegrate. What will happen is dust and moisture will get into the voice coil and cause a short, even though the speaker still plays. Hope this helps. If you need more help or just advice, post a comment, and I'll help if I can

Technics... | Answered on Apr 21, 2016


Yes,

Connection guide:


9_7_2012_9_41_10_am.jpg


hope these helps,

thanks for choosing Fixya for assistance!

Technics... | Answered on Sep 07, 2012


Hey, The model of the amplifier is SU-G91 Technics.....If you could help......Thank you.

Technics... | Answered on Aug 07, 2011


Here's the manual with all the specs...

http://www2.panasonic.com/consumer-electronics/support/Audio/Technics-Audio-DJ/Technics-Receivers/model.SA-EX320

LIke most amps, it is designed for 8-ohm nominal loads.

Technics... | Answered on Jun 28, 2011


press and hold the station button for 10 seconds

Technics... | Answered on Jan 10, 2010


do you have the volume turned up all the way? do you have the sub turned up all the way? thats probably why its overlading.

Technics... | Answered on Jul 12, 2009


The problem is in cooling fan. It is with sleevberling . you can buy another one(they sell only the motor) or buy just a simple motor from any electronics shop and chenge just a berlings (on each side), if uoy can. be carefull not to crack them on the new one.

Technics... | Answered on Apr 28, 2009


If my comments helped you, could you respond accordingly to the fixya survey.

thanks...

Charlie

Technics... | Answered on Apr 22, 2009


I would guess that the switching chip is faulty inside the receiver. Since the CD works OK, the amplifier section and pre-amp section are good. What you are hearing with the others is crosstalk. This chip shouldn't be more than about $10-$15. Add in the local labor rate for the total repair cost. I think that the chip for your model is a TC9163.
Dan

Technics... | Answered on Jun 02, 2008


This posting is very old but the answers unhelpful so I thought I'd chime in. I have the same receiver and there is not mute button on the front panel, nor does the volume do anything. Put it on, select the tape or other aux. input. Press and hold the Phono button for several seconds and the mute light should go off and the volume get much louder.

Technics Audio... | Answered on Jan 21, 2021


Go down to Walmart and get CD Cleaning Disc. They have little brushes that clean the optics.

Or it is a counterfeit copied disc and has become corrupt!

Try the discs on another unit.

Technics Audio... | Answered on Dec 26, 2020


This will show you
https://www.manualslib.com/manual/387769/Technics-Sh-Ge90.html

Technics Audio... | Answered on Dec 23, 2020


Display or control board failure

Technics Audio... | Answered on Dec 10, 2020


its cd lens weak or defective solution replace lens

Technics Audio... | Answered on Dec 09, 2020

Not finding what you are looking for?
Audio Players & Recorders Logo

20 questions posted

Ask a Question

Usually answered in minutes!

Top Technics Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5700 Answers

The Knight
The Knight

Level 3 Expert

76466 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Are you a Technics Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Technics Audio Players & Recorders

  • Technics Audio Players & Recorders

Most Popular Question

technic gn3 organ 3 1 2 floppy drive

  • Audio Players & Recorders
Loading...