20 Most Recent Radio Shack Wireless Weather Forecaster - Page 5 Questions & Answers


The sensor should flash briefly when you put in good batteries. Afterwards it should flash about every couple of minutes. If you have a voltmeter check the batteries are at least 1.3 volts (the voltage will drop when they get colder). Ideally they should be about 1.4-1.6 V. Try cleaning the battery compartment contacts and springs with a cotton bud and alcohol. If the contacts look rusted then use fine emery paper or scrape with a screwdriver to remove the rust and tarnish. Clean the ends of the batteries by rubbing with a tissue or cloth. When inserting new batteries twist them inside the battery housing to help make better contact. Another thing you might try is to use a screwdriver to very carefully stretch the springs in the battery compartment a little to allow better contact. (Warning do not pull the spring too hard so as not to damage it) If using new batteries does not help then the sensor may have a fault. If the led on the outdoor sensor is flashing but the indoor sensor does not pick up the signal you can try putting the indoor sensor closer to the outdoor sensor. Otherwise you may need to re-tune the indoor sensor to the correct frequency (there is a small adjustable screw inside).

Measuring Tools... | Answered on Aug 31, 2019


last four of phone no.

Measuring Tools... | Answered on Aug 24, 2019


Radio Frequency communication may come and go occasionally. This can be normal in some environments (e.g. moister climates). If transmitter signal is lost, please wait 2-4 hours for the signal to reconnect on its own.

Here is a link to the User Manual for your product.
https://www.lacrossetechnology.com/media/catalog/product/w/s/ws-8119u-it__faqs_1.pdf

Measuring Tools... | Answered on Aug 18, 2019


Hi Bogdan.
i think the LCD is not good.
if it is possible to replace it???

regards.
nuwan

Measuring Tools... | Answered on Aug 15, 2019


try new test leads first. even if the unit is miscalibrated, you should get the same measurements from the same components/circuits. you'll need to send the unit to a calibration center, or the manufacturer, to get it zeroed out, if you still need to afrer getting new test leads

Measuring Tools... | Answered on Aug 13, 2019


Here is your answer: http://plumbr.eu/blog/how-do-leak-detectors-work-plumbr-case-study

Measuring Tools... | Answered on Jul 22, 2019

Not finding what you are looking for?
Radio Shack Wireless Weather Forecaster Logo

Popular Tags

27 questions posted

Ask a Question

Usually answered in minutes!

Top Radio Shack Measuring Tools & Sensors Experts

Cindy Wells

Level 3 Expert

6198 Answers

Brad Brown

Level 3 Expert

18520 Answers

Harrie

Level 3 Expert

6746 Answers

Are you a Radio Shack Measuring Tool and Sensor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Radio Shack Measuring Tools & Sensors

  • Radio Shack Measuring Tools & Sensors

Most Popular Question

replace sensor radio shack 63 1090

  • Measuring Tools & Sensors
Loading...