20 Most Recent La Crosse LaCrosse Technology Professional Weather Station - Page 8 Questions & Answers

Do you have a setting for the power line frequency? Some devices get their timebase from the power line frequency and if your powerline is 60 Hz, but you have it set on 50 Hz, then it will speed it up because of the 10 extra cycles per second.

Measuring Tools... | Answered on Sep 07, 2019

The sensor should flash briefly when you put in good batteries. Afterwards it should flash about every couple of minutes. If you have a voltmeter check the batteries are at least 1.3 volts (the voltage will drop when they get colder). Ideally they should be about 1.4-1.6 V. Try cleaning the battery compartment contacts and springs with a cotton bud and alcohol. If the contacts look rusted then use fine emery paper or scrape with a screwdriver to remove the rust and tarnish. Clean the ends of the batteries by rubbing with a tissue or cloth. When inserting new batteries twist them inside the battery housing to help make better contact. Another thing you might try is to use a screwdriver to very carefully stretch the springs in the battery compartment a little to allow better contact. (Warning do not pull the spring too hard so as not to damage it) If using new batteries does not help then the sensor may have a fault. If the led on the outdoor sensor is flashing but the indoor sensor does not pick up the signal you can try putting the indoor sensor closer to the outdoor sensor. Otherwise you may need to re-tune the indoor sensor to the correct frequency (there is a small adjustable screw inside).

Measuring Tools... | Answered on Aug 31, 2019

last four of phone no.

Measuring Tools... | Answered on Aug 24, 2019

Radio Frequency communication may come and go occasionally. This can be normal in some environments (e.g. moister climates). If transmitter signal is lost, please wait 2-4 hours for the signal to reconnect on its own.

Here is a link to the User Manual for your product.

Measuring Tools... | Answered on Aug 18, 2019

Hi Bogdan.
i think the LCD is not good.
if it is possible to replace it???


Measuring Tools... | Answered on Aug 15, 2019

try new test leads first. even if the unit is miscalibrated, you should get the same measurements from the same components/circuits. you'll need to send the unit to a calibration center, or the manufacturer, to get it zeroed out, if you still need to afrer getting new test leads

Measuring Tools... | Answered on Aug 13, 2019

Here is your answer: http://plumbr.eu/blog/how-do-leak-detectors-work-plumbr-case-study

Measuring Tools... | Answered on Jul 22, 2019

Not finding what you are looking for?
La Crosse LaCrosse Technology Professional Weather Station Logo

4 questions posted

Ask a Question

Usually answered in minutes!

Top La Crosse Measuring Tools & Sensors Experts

Cindy Wells

Level 3 Expert

6099 Answers


Level 3 Expert

85239 Answers


Level 3 Expert

2608 Answers

Are you a La Crosse Measuring Tool and Sensor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

La Crosse Measuring Tools & Sensors

  • La Crosse Measuring Tools & Sensors

Most Popular Question

lacrosse wss 1912 1t weather station

  • Measuring Tools & Sensors