20 Most Recent Pentax ME Super 35mm SLR Camera - Page 9 Questions & Answers

try http://the-manuals.com/

http://the-manuals.com/

Check/clean the mirror first, then the viewfinder and the lense. If the stain doesn't show on pictures, it's probably just in the mirror or the viewfinder and doesn't affect the pictures.

http://the-manuals.com/

Clean the battery cap and contacts with a pencil eraser including the cap threads.
there are no new parts available for this model Pentax, so a good used part repair could be expensive.
An inexpensive hand held light meter might be the way to go if the cleaning did not work, and the camera is otherwise working good.

the winder should stop when the camera counter is on # 1. take the winder off the camera and clean the winder contacts on the bottom of the camera with a pencil eraser. also be sure that the winder is coupling to the advance shaft correctly. not much else you can do as there are no new parts available for this winder.

Hi,

You can download the manual from here http://www.pentaximaging.com/support/manuals-and-literature/

Please note that P3N = P30N

Hope this helps.

Thanks,
Kanu

When loading film, make sure to draw the film all the way to the receiving spool. If you don't pull the film far enough the camera thinks it's empty and rewinds the film.

Try manual mode. Replace batteries.

It can be replaced only by a trained service technician. Check the Pentax website for a service center near you.

You probably didn't get the film leader caught by the takeup spool - they might be no pictures taken at all. Go into a dark room and open the back, you can feel if the film is loaded.

the battery inlet is located at the side panel.

rate this

Pentax fan

There is a spring in the way. straighten a paper clip and from the top of the camera push it out of the way while you gently push the shaft up. rotating the shaft helps.
or you could file a little of the shaft collar on an angle ( if it's not there ) then rotate the shaft while gently pushing up. don't bend the spring.

Remove the lens and clean the contacts between the body and the lens with a pencil eraser. Make sure the camera is on Autofocus mode. If these don't solve the problem, take it to an authorized service center.

Hey sorry i dont have an answer but i have the same camera can you help me?

Here you go:

http://safemanuals.com/user-guide-instructions-owner-manual/PENTAX/IQZOOM%20105R-_E

Shutter speed?
Manual here

http://safemanuals.com/user-guide-instructions-owner-manual/PENTAX/MV1-_E