20 Most Recent Mitsubishi VS-50609 50" Rear Projection Television Questions & Answers

0helpful
1answer

How to get the buttons to work agin on front of tv.

You may have accidentally set it to the demo mode. The user's guide might help: Mitsubishi VS 45609 VS 50609 User Guide
9/6/2014 4:08:00 PM • Mitsubishi... • Answered on Sep 06, 2014
0helpful
1answer

Unit comes on for 2-5 sec. then shuts down

Probably has lost convergence chips and fuses. But keep in mind--these sets often get a LOT of capacitor problems and fulid leakage problems too--so be aware of this.
5/8/2014 1:03:55 AM • Mitsubishi... • Answered on May 08, 2014
0helpful
1answer

Mitsubishi vs-50609 green timer light comes on no

Unplug the tv and leave it unplugged for a couple hours. Plug tv back in press reset button. TV led may flash for a day but should come on. I did this last night to mine and it came on at 11am today.
2/23/2014 7:49:00 PM • Mitsubishi... • Answered on Feb 23, 2014
0helpful
1answer

Mi problema es con mi mi televisor mitsubishi vs-50501 enciende y cuando va a entrar la imagen se apaga a veces si entra y se ve medio rara como que tiene dos imagenes un poco separada o se ve la imag

I have a wd-57731 The lamp light blinked orange. i replaced the lamp turned the tv on and the timer blinks green for one minute and then the lamp light blinks orange again. It won't turn on. Can you suggest anything?
12/19/2013 8:56:12 PM • Mitsubishi... • Answered on Dec 19, 2013
0helpful
1answer

Tv tuner dk whats going on?

Yes, you can play DVD movies on TV, you need the tuner if you want to see broadcasted channels.Your universal remote should have codes for Mitsubishi Rear Proj. Tv's. If you dont have the instructions with the remote , call the manuf. Good luck!
11/14/2013 6:26:03 AM • Mitsubishi... • Answered on Nov 14, 2013
0helpful
1answer

Fuzzy picture

when you take the front screen off the screen maybe dusty or the projecters are bad or the oil is burned. when you open them if theres a brown film over them the fluid is burned. the tv is not worth the cast of them or the fluid
11/13/2013 6:26:55 PM • Mitsubishi... • Answered on Nov 13, 2013
0helpful
2answers

[email protected]

I think your in SAP mode.....couldn't unstand a word your saying.
8/27/2013 8:21:40 PM • Mitsubishi... • Answered on Aug 27, 2013
0helpful
1answer

Is it a difficult to replace the convergence amplifier modules on a Mitsubishi VS 50609 TV?

Your convergence has failed. This is a very common problem on most projection tv sets. You can read about it here on fixya using this linkhttp://www.fixya.com/support/r2861467-solution_video_looking_whiteish_dull-----------------------------------------------------------------------------------------------
4/10/2013 6:09:43 PM • Mitsubishi... • Answered on Apr 10, 2013
0helpful
1answer

Picture tube for 60 in' mitsubishi it shows only a black screen but you can still hear it

ts will go into shutdown when a vertical issue is present but the audio will still continue to operate normally.
4/2/2013 1:01:14 PM • Mitsubishi... • Answered on Apr 02, 2013
0helpful
1answer

-Convergence IC replaced -Colors unmovab

you are going to need a ohm meter and they will be low value resistors--color bands denote the value and they have to be tested, do not think its possible for me to tell you which to replace as I would check them to know which.You might find the service manual with Google for free at scribed.
11/7/2012 5:10:49 PM • Mitsubishi... • Answered on Nov 07, 2012
0helpful
1answer

Vs-50609

Either a bad solder connection in the Convergence circuit or the chip/s used need to be replaced.
6/26/2012 10:32:04 PM • Mitsubishi... • Answered on Jun 26, 2012
0helpful
1answer

Mitsubishi vs-50609 need to get back off to put in room

Its a one piece screwed and glued cabinet that cannot be taken apart.
5/31/2012 5:35:34 PM • Mitsubishi... • Answered on May 31, 2012
0helpful
1answer

Tv works fine but shuts itself off after awhile, why

To get an idea of why the set is shutting down when it does shut down if power light goes out do the self check this set should have.Does the power light go out when it fails?
4/23/2012 3:39:05 PM • Mitsubishi... • Answered on Apr 23, 2012
0helpful
1answer

Mitsubishi Big screen TV, can't adjust the blue

Sounds like you may have a bad convergance ic.
2/29/2012 7:08:23 PM • Mitsubishi... • Answered on Feb 29, 2012
0helpful
1answer

I have a sony kds-r50xbr1

Sir try to reset the lamp timer. you should press the "display" button on the remote then "5" then the "volume up key" and power "on" you should do this while the tv is in standby mode. Then press "Jump" 3 times to enter the DE service menu. Your tv will display the total lamp hours. Reset the lamp time by pressing channel 3, then mute, then enter. this will make your lamp hour timer to zero. Good day and best regards.
8/21/2011 1:55:00 PM • Mitsubishi... • Answered on Aug 21, 2011
Not finding what you are looking for?
Mitsubishi VS-50609 50" Rear Projection Television Logo

112 questions posted

Ask a Question

Usually answered in minutes!

Top Mitsubishi Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76851 Answers

Jaime Hernandez

Level 3 Expert

2343 Answers

Cindy Wells

Level 3 Expert

6526 Answers

Are you a Mitsubishi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Mitsubishi Televison & Video

  • Mitsubishi Televison & Video

Most Popular Question

fuzzy picture

  • Televison & Video
Loading...