Mitsubishi VS-6055 60" Rear Projection Television - Answered Questions & Fixed issues

Use a keyboard though usb port or take to cable provider.

Everything pluged in correctly? If so the Are you hitting the correct button? Also what kind of multi-switch do you have? and Is that plugged in correctly

I can help you unlock your Mitsubishi HDTV V-Chip parental lock.

Please follow these steps to bypass the vchip or reset the V Chip password.

I hope that helps.
_______________________________________________
Reset Mitsubishi HDTV VChip Password
Bypass Mitsubishi HDTV Front Panel Lock

It seems that your unit has some sort of Thernmal problem or a problem that is shutting down the Power Supply section to the Video side of things.
You need to take the unit to a reputable service centre/man and ask for a firm "Quote" for the work to be done.

Yes,because the 60' it expensive,worth repairing.It will cost u $500 parts and labors.Any big screen tv tech.will able to repar it.

Call for warenty service tell them it ur convergence is about to die.Must replaced the whole convergence board or the ICS.

check q570 if shorted replace it,also regulator ic401 goes bad along with c402 100mf/50volt electrolytic cap

every rear projection tv has a projection bulb at the back yours is blown it will cost about $300-400 new zealand dollar to get a new one just buy a new tv preferably high definition lcd-plasma.

Call a good TV Tech and tell him the problem is the convergence amp IC's are bad and need replacing. This should not cost over $325

If this TV turns back only when it is cooled down than it has cold solder joints tha have to be resolderd.

Poer supply is the cause of the shutdown and would need to be replaced. These cost around $150 bucks just in parts the labor you would need to find someone that knows just what there doing or you could wind up into the hundreds, Thanks Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

This is due to bad caps read here what a cap is www.badcaps.net see you tv is getting hot as normal but the caps cannot stand it any more thus shutting the tv down. The bad caps would be more or less in the power supply unit of this TV. So you can buy a new psu or get it repaired by a expert. Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

Is the a mitsubishi or hitachi tv?

What is the problem? And I have heard a lot in my rime but magnetized dust??? You did not really say what the problem you are having.

Those three Knobs were the focus or screen controls . your problem may be dust and dirt on the lens or the tubes could be getting soft. It could also be a convergence trouble and thats very common in these sets . a picture would be nice see where your problem lies BUT let me warm you down there where you were plying and turning those little knobs is about 32000 volts!!did you know this ? A tv set is not something to experiment with as it could kill ya. Unless you have technical background in electronics I would call a servicer to assist you. Good Luck

The lamp is not enabled possibly due to the colour wheel motor not turning. Any broken glass jamming it? Or the lamp ballast has failed due to an old/worn lamp.

Most likely you need to replace the projection bulb. You can find them online. DLP sets are famous - or infamous - for burning out the bulbs/lamps.

Your Mitsubishi VCR HS-U580 looks to have a problem with the information rollers and drum. Here are some things to check: Look for something blocking the VCR or cassette compartment that would possibly be stopping the guide rollers. Check the belt that drives the VCR mechanism. If it is loose or broken, you may also need to substitute it. Clean the video heads using a head-cleaning cassette to make certain they're not dirty. See if the drum motor is working. If it is not spinning, there may be an issue with the motor. If the trouble persists, it's an exact idea to get assistance from a professional technician or contact Mitsubishi's purchaser support for advice. Be cautious when dealing with electronic devices, and if you are not certain what to do, it's great to get assistance from an expert.

i think finding a downloadable service manual for your Mitsubishi HS-U580 VCR might take some searching, but here are a few options: Check the official Mitsubishi website's support section. They might offer downloadable manuals for older models.Many online appliance parts stores like RepairClinic or AppliancePartsPros stock service manuals for various brands and models. Search for your specific VCR model to see if they have it available.Websites like ManualsLib or iFixit sometimes host user-uploaded service manuals. While the availability and quality can vary, it's worth checking. If online options fail, consider purchasing a physical copy of the service manual from online marketplaces like eBay or Amazon. Remember, some websites might charge a fee for downloading manuals. Always be cautious of suspicious websites and download from reputable sources.

http://www.manualsonline.com/support/mitsubishi/vcr/manual-262223 Try this site for your manual