20 Most Recent Mitsubishi VS-45605 50" Rear Projection Television - Page 8 Questions & Answers

0helpful
1answer
0helpful
2answers

The picture on my Mitsubishi WS-73411 TV goes off after an hour or so. I checked the error code on the flashing LED's and I get a 23. Any solutions?

The main power supply regulator section circuit fault. Either it will be a separate board, or the part of main board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and time. Even though you can make it right, it will cost around an amount equal to the cost of a new board; including the cost of (spare parts + service charge) More to say, most of the spare parts to it will be difficult to get from open electronic spare part market. This is true to most of the flat panel TV power supply boards; irrespective of its brand and screen size
1/13/2020 9:32:25 PM • Mitsubishi... • Answered on Jan 13, 2020
0helpful
1answer

I have a Mitsubishi tv model 60738 and I replaced the bulb but it still wont come on it blinks green for a bit then flashes 6 red and 1 yellow do you know what is causing this thank you

These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices. http://electronicshelponline.blogspot.com/ Blinking codes details to many popular brand TVs are given. Surf the site with patience. If blinks continue without any pause, the main board is faulty. Counting of number of blinks to Philips TVs is entirely different to that of other brand TVs. It is not a direct count procedure. The site have details about how to count the number of LED blinks [Fault Codes] to Philips brand TVs are given; along with details of the faulty circuit location.
12/15/2019 5:16:16 PM • Mitsubishi... • Answered on Dec 15, 2019
0helpful
1answer

TV MITSUBISHI 1080 WILL NOT STAY ON

If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/ faults & possible causes to LCD screen are given with illustrations. You can get an idea about the fault to an extent.
11/14/2019 1:03:57 PM • Mitsubishi... • Answered on Nov 14, 2019
0helpful
1answer

I forgot my password to my mitsubishi tv. What can I do?

If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/
11/14/2019 12:54:42 PM • Mitsubishi... • Answered on Nov 14, 2019
0helpful
1answer

I have a Mitsubishi WS-55315. I usually listen through my AV receiver. I want to turn the internal speakers on. It shows that the internal speakers are on, but there is no sound

Try plug and unplug headphones, see if sound comes back, could try a reset of tv.
10/22/2019 10:28:23 AM • Mitsubishi... • Answered on Oct 22, 2019
0helpful
1answer

My mitsubishi tv wd82738 is flashing 6 red and 1 yellow trying to find code so that i can fix

The was a previous answer on Fixya ( John Betancourt Apr 25, 2019 What I did I open it up and removed the panel and clean out the fan.it was very dusty.) I'm not sure that it will fix you problem but if it does let me know. There's a video on youtube which will a bit more helpful. It's called "Mitsubishi DLP TV Repair - TV is Blinking - How to Identify Blink Codes & Fix DLP TVs". https://www.youtube.com/watch?v=INird71KKtA
10/20/2019 5:48:11 PM • Mitsubishi... • Answered on Oct 20, 2019
0helpful
1answer

Mitsubishi mge2900foc output low what could it be

Have the internal voltage regulator checked. Possible that it's failing.
9/9/2019 2:35:05 AM • Mitsubishi... • Answered on Sep 09, 2019
0helpful
1answer

Mitsubishi WD73838 DLP TV formatter board replacement instructions

Hi Patrick, I pass the link to the service manual of your Mitsubishi TV I hope you can resolve your concern Greetings Franco Dosil Hola Patrick, te paso el link del manual de servicio de tu TV Mitsubishi Espero puedas resolver tu inquietud Saludos Franco Dosil https://elektrotanya.com/mitsubishi_wd-60638_65638_73638_60738_65738_73738_82738_65838_73838_82838_60c10_65c10_73c10_chassis_v43_v43c_v43-plus_sm.pdf/download.html
9/5/2019 4:31:26 PM • Mitsubishi... • Answered on Sep 05, 2019
0answers
0helpful
1answer

Mitsubishi "wd73642 I'm watching tv and then it shuts off and the status green light blinks green fast and the light goes off do i need a new dlp lamb

I have a Mitsubishi WD73642 model which I'm having a problem with it turning off. When power is turned on the status light flashes green and appears to be powering up. Then u hear sound. Picture comes on light turns sold green then within a minute the El TV will just turn off no other dianososis lights. TV is not located too close to the Wall. Any ideas why?
6/17/2019 1:54:59 PM • Mitsubishi... • Answered on Jun 17, 2019
0helpful
2answers

I have a 65" mitsubishi model wd-65733 with sound but no picture

The bulb is out. You can purchase on amazon for around $20.00. It is a very simple fix. Should take about 5-10 minutes
6_16_2019_4_29_21_am.png
6/16/2019 4:57:31 AM • Mitsubishi... • Answered on Jun 16, 2019
0helpful
1answer

Mitsubishi dlp 60735. Has a new bulb, been dusted, self diagnosis blinks 1-2 but still shuts itself off after about 20 seconds. What do I do now?

Sounds like its overheating.
Are the fans working properly?

Did you buy a quality bulb (or one of the cheap junk bulbs around $20-$30?)
6/14/2019 2:13:54 AM • Mitsubishi... • Answered on Jun 14, 2019
0helpful
1answer

Hi: why is it that when i turn on my mitsubishi tv model wd-82c12 the volume is all the way up and i can't turn it down?

The volume button on the remote or the TV is stuck. Try this first, Turn the TV on from the TV (put the remote in a different room) now turn it down from the TV if the volume stays down, the remote up volume is stuck. If it stays loud The main TV board needs to be replaced. If it stays down carefully take the remote apart. check for tiny screws in the batteries compartment if no screws it all clips. Now clean the remote (try not to touch the curcit board).
6/11/2019 12:57:39 AM • Mitsubishi... • Answered on Jun 11, 2019
0helpful
1answer

I have a mitsubishi perfectape vhs player. I was wondering how i adjust the tracking on the player so the tapes don't jitter when they show the picture? model number HS-U580

Do you have the model number available? It should be on the back or bottom of the unit. Before adjusting, clean the heads and verify that the tape is running at the proper height past each head. There are three head assemblies to inspect: the rotating video head, the stationary sync head, and the stationary audio head. The sync signal is on the top edge of the tape and the audio signal is on the bottom edge. If the sync head or an adjacent guide pin has come loose, that could cause tracking problems. Caution: the video heads are very delicate. They're located in the slots at the bottom edge of the rotating drum. Use a foam-tipped swab with straight isopropyl alcohol, and gently wipe the heads in the same direction as the tape goes (do not wipe perpendicular to the tape direction; you could snap the head off if it snags on the swab).
6/4/2019 11:33:38 PM • Mitsubishi... • Answered on Jun 04, 2019
0helpful
1answer

Mitsubishi Wd-73638 code 6 red 1 yellow not sure what that is please help

No error code 61 listed, only a 66 error code which indicates lamp issues: 66 A) Lamp did not turn on at P-ON sequence... Check CJ4 circuitry B) No Lamp Inserted............... No Lamp inserted C) Disconnected cable between ballast and lamp.... HV connection or lead wire to lamp. D) Lamp-Enable goes to PWB-MAIN but not to Ballast....Lamp Cartridge Failure for lamp see the following web site: http://www.shopjimmy.com/dlplamps?tv_brands_select=Mitsubishi&tv_models=Mitsubishi+WD-73638 recommend using the manufacture part# as many replacements for Mitsubishi will not work.
5/9/2019 2:34:30 AM • Mitsubishi... • Answered on May 09, 2019
0helpful
1answer

Why won't my Mitsubishi series 837 tv stay on.

Shorted circuit board.
4/10/2019 10:49:21 PM • Mitsubishi... • Answered on Apr 10, 2019
Not finding what you are looking for?
Mitsubishi VS-45605 50" Rear Projection Television Logo

85 questions posted

Ask a Question

Usually answered in minutes!

Top Mitsubishi Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76823 Answers

Ekse

Level 3 Expert

13435 Answers

Cindy Wells

Level 3 Expert

6413 Answers

Are you a Mitsubishi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Mitsubishi Televison & Video

  • Mitsubishi Televison & Video

Most Popular Question

comes goes off

  • Televison & Video
Loading...