20 Most Recent
Ricoh FT5832 Copier - Page 5 Questions & Answers
Received "SPAM has been formatted
Not that I am aware of... could it mean "SRAM" instead? It sure looked like SPAM but that was proposed to me as well.
I don't know how it woild store email when there is no program in it as far as I know.
Thanks for the response, I'll look into that possibility too.
Ricoh FT3713
Try to properly close the cover and also the Drum Section
Copier Failure Konica
If there are no obvious paper pieces stuck, you could have either a problem with the dirty or worn rollers in the ADU, a dirty or defective sensor, or most likely a clutch problem in the ADU. Likely will require a service tech on site to repair to no obvious defects are seen.
Error codes
Try to check the fuser section.
- Check the Lamp
- Check Motor Assembly
Ricoh FT5535
Either the lens sensor is not seeing the lens at home position, or the lens is not getting there. Also check fuse 303 on the DC board.
Error code E103
there are three posible causes for the above mentioned problem
- Scanner lamp blown
- thermistat blown
- Home position sensor is not working
One or a combination of these three conditions will cause E103 and hense you can replace as appropriate.
Sc 285 sur un photocopieur ricoh
You either have a torn ITB belt or a faulty ITB belt unit.
If this is not your problem then you could have a faulty ID sensor or a faulty PCU that is causing your Process Controll to fail and generate the SC285.
How can I fix a malfunctioning Ricoh 3410 printer?
On this page see error code 542.
Error Codes > Ricoh > SP3410DN > page 2 (printcopy.info)
- Code: 542
- Description: Fuser reload error
This SC is issued if one of following conditions occurs: The fusing temperature rises 8°C or less in 1.5 seconds; and this continues 5 times consecutively. -or- The fusing temperature has not reached 45°C within 9 seconds (after the fusing lamp comes ON while the machine is warming-up). -or- The fusing unit does not attain reload temperature within 35 s. (normal temperature) or 65 s (lower temperature - the thermistor output is less than 18°C) after the fusing temperature control starts.
Not finding what you are looking for?