Top 20
Ricoh Aficio 1035 Copier Questions & Answers
Can not find ip address on richo 1035. I tried to
Connect the machine to a router or a switch with a network cable.
In used mode, under network settings - set the machine to DHCP, so it will get an IP adress from the switch/router.
Print out a network status page, and see if you've got an IP adress.
In the command window on your PC type: ipconfig/all and see the IP adress of your computer. Compare it to the adress the machine got from the router/switch and see if they are almost identical apart from the last digits.
Install the driver, and install the printer using device name, and you should be good to go. Or you can set the IP you got from the switch/router as a static adress, and install the copier using the IP adress.
Reset error code
press the orange key for say three times and press '107' and place your hand on the 'clear/stop' key for about thrre times .
themachine will take you tothe system sp .
turn off the machine and tuen it on after about A MINUTE .
THANS
Ricoh aficio 1035 copier gives error code 390
TD sensor defective
TD sensor not connected or disconnected damage
Poor connection between the TD sensor and IO board
IO board defective
Toner supply defective
* Insufficient toner in developing unit
Error code sc546
546 is an unstable fusing temperature:
-Fusing thermistor defective
-Power supply board defective
-Defective connection of fusing unit
Functional problem
change the td sensor below the developer unit or if possibly change the complete developer unit
Error code SC 352
SC352
Error Code Explanation :
ID sensor, pattern edge detect error
The ID sensor pattern edge voltage is
detected to be not 2.5V twice
consecutively during an 800 ms
interval.
Posible Causes :
• ID sensor defective
• ID sensor connector defective
• Poor ID sensor connector connection
• I/O board (IOB) defective
• High voltage supply board defective
• Dirty ID sensor
• Defect at the ID sensor pattern
writing area of the drum
Sc 305 dsc 224
The error code sc 305 is a charge corona wire cleaner error. Has the pcu or charge corona assy been replaced or removed for any reason?
Where is ID Sensor?
slide the drum out through the front - open right cover open and the id sensor is towards the back of the machine in the drum cavity. its a black square on the roof with a pcb and sensor on the inside of it.
Error code 1045
unplug machine , open the front door there should be a 1/4 inch by 1 inch 'window' showing numbers this is the copy count, on the backside of counter there is a small plug that is not plugged in - plug it into the counter, , plug copier back in back in and code should be gone
Not finding what you are looking for?