20 Most Recent
Ricoh Aficio 1035 Copier - Page 9 Questions & Answers
Ricoh aficio 1045 - SC541
Fusing thermostat/thermistor open
Symptom: The fusing temperature detected by the
thermistor is below 10°C for 5 seconds
after the main power switch is turned
on.
Possible Cause:
• Fusing thermostat defective or out of
position
• Fusing thermistor defective or out of
position
• Power supply board defective
Sc 329 code. Service the laser unit but cannot
Replace the harness that runs from the front of the lazer housing to the back of the machine's main board. It should be a long ribbon cable. This cable is super sensitive and any small bends or pinches will damage the ouput/input of the lazer information. If this doesn't fix your issue, it may be a short in your board.
How to find out where
Ricoh Aficio 1035 have two meter those are the electronic counter and the magnetic counter type but they are program to synchronize. to look for the magnetic counter just open the front door and you will find it at the middle and to open the electronic counter just press the user tools/counter key located on the upper left side of your operation counter then press the counter on the LCD display. Hope this helps, thanks for using Fixya
Hi get error sc 395
sc395 on a Ricoh 1035 is an abnormal development output error. Did you recently change the toner, or remove the development unit or drum unit? If nothing is out of place and the error doesn't go away when you power down and reset the machine, you might need a new high voltage supply board.
If you recently took the developer unit out, check to make sure everything is seated right in it. Also check the terminal jack in the machine, where the developer unit plugs into (the one that looks like a phone jack). Make sure it is not broken or knocked out of place.
How to get ride of horizonal and vetical lines revealed in paper
this problem means that laser unit cable is defective try to cutting it and scratching until solid pins revealed again and pack it in his position properly and before do that unplug power cord and machine some times appear again rolling right or left changeable resistor first one yo have two in your machine to left try more times.andwe must realize that this lines revealed too much in paper
I have sc564 trouble with
look my friend this problem belong to thermistors are corrupted change it and it will work correctly there are many ways to solve this problem temporally but it revealed again 1 hour 6 hour and raise again thus change it byy
1045 sc402
this proplem means that you have two spings charge tranfer unit when yo opened side door and yo will see two springs one or two springs missing or out of position
How to make a connection between the pc and photo
you need to determine what kind of cable you need, either parallel port type or USB, once you determine that and if you didn't get a cable with your copier, go buy the one you need. Your copier should have also come with a driver and software disk if its intended to be hooked up to a computer.
I have aproblem sc402 when westart button tomake
That is a current leak in the Transfer Unit.
At best, maybe something is out of the place (on the transfer unit like transfer roller)
However i advise you to call your provider because it can be a High voltage Supply board defective or a Transfer Connector cable defective.
In any case i advise you to call a specialized technical support
Sc690 for ricoh 1035
That is not an easy task...
From what the manual says you have a BICU defective. Looks like a bad connection or somethings.
I advise you to call your provider. I think there is nothing you can do
Not finding what you are looking for?