20 Most Recent Ricoh Aficio 1035 Copier - Page 5 Questions & Answers

SC 352 problems can be.

• ID sensor defective

• ID sensor connector defective

• Poor ID sensor connector connection

• I/O board (IOB) defective

• High voltage supply board defective

• Dirty ID sensor

• Defect at the ID sensor pattern writing area of the drum

I guess on one of the two latest

I have a Mita DC -1860 it wont make any copies it say AP what is this AP mean thanks

problem with the controller board replace to solove the problem

Another poblem with this machine is that the sync detect for the 400 dpi and 600 dpi could be off. Go into service modes by pressing the yellow clear modes key then pressing the numbers 1 0 7 then hold done the red stop key till you see the display change. Now go into copy sp, then hit the 2 in the window {drum}, next use the page down button located in the middle of the screen till you see the one that says 2109 LD Beam Pitch Adjust. Go to number 2109-8 beam pitch data reset. execute then go to 2109-1 and set it to 144 then hit pound. Now go to 2109-3 and execute. last go to 2109-2 and set it to 168 then hit pound. Now go to 2109-4 and execute. exit out of the service modes window. now try to run a copy and a print. If these fail the you either need to clean the laser assembly, a polygonnal mirror moror or laser drive unit.

replace toner supply unit. inside of the unit are 4 mylars to push toner towards hopper exit gate. looks like them mylars are ripped off and the toner is not getting to the dev unit

Step 1:

nter in SP mode

Step 2:

Step 3:

Step 4:

In SP mode SP 5-803 Main machine input check.In SP mode SP 5-804 main machine output check.

SC 395 Development output abnorma.Remove the development unit and clean the gears.If necessary change the developer.Remove the OPC imaging unit and clean the cleaning blade.

Hi you should check the lower corona block cleaning motor or the cleaner got stuck

sir namaskar connon ir400s copy one side light..

Press # - Interrupt key - C -Interrupt - Main code - Start - subcode - Start.

The lens is located in exposure area under original glass.

After replacing the laser unit you need to perform LD beam pitch adjustment in SP 2109 mode.